EK-Quantum Vector Terminal Cover User manual
USER GUIDE
EK-Quantum
Vector Terminal Cover
This product is intended for installation by expert users only. Please
consult with a qualified technician since improper installation may
result in damage to the equipment. EK assumes no liability whatsoever,
expressed or implied, for the use of this product, nor its installation. The
following instructions are subject to change without notice. Please visit
our website at www.ekwb.com for updates.
Before you start using this product, please follow these basic guidelines:
Carefully read the manual before beginning with the
installation process.
- 4 -
Allen Key 2 mm
BOX CONTENTS
M4
4
M4 x 4 Hexagon Socket Screw
EK-Quantum Vector Terminal Cover
- 5 -
TERMINAL COVER DIMENSIONS
14.50 mm
85.10 mm
29.50 mm
24.85 mm
EK-Quantum Vector Terminal Cover is compatible with EK-
Quantum Vector Water Blocks with two-piece terminal design
as with EK-Quantum Scalar Flow Indicator and with EK-Quantum
Scalar Multi GPU terminals.
COMPATIBILITY
- 6 -
INSTALLING THE EK-QUANTUM VECTOR TERMINAL COVER
STEP 1
Carefully detach the terminal cover together with LEDs from the GPU
terminal. The latest EK water blocks come with no screws – all you
have to do is pull the cover away from the terminal.
EK-Quantum Vector Terminal Cover does not include any
LEDs. Detach the Terminal LED cable from the LED strip
as it is not needed. Be careful not to unplug the part of the
LED strip that illuminates the water block.
STEP 2
Position the EK-Quantum Vector Terminal Cover on the Terminal
(Flow Indicator) of the water block with the help of milled markings
behind the front side.
STEP 1
STEP 2
TERMINAL COVER
Milled markings to help
position the cover on
the terminal.
- 7 -
Example of attaching the cover on one of the GPU terminals.
Example of attaching the cover on the EK-Quantum Scalar Flow
Indicator.
- 8 -
STEP 3
Using the 2 mm Allen Key screw in the two (2) M4 x 4 Hexagonal
Socket Screws supplied with the Terminal Cover.
Be careful not to use excessive force when tightening
the screws as it is only necessary for the cover to remain
on the Terminal (Flow Indicator)!
STEP 3
EXAMPLE OF THE FINAL LOOK
In case you need assistance, please contact:
http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SUPPORT AND SERVICE
SOCIAL MEDIA
Table of contents
