ekwb EK-Vardar 240 User manual

USER GUIDE
EK-Vardar
Fan Set

This product is intended for installation only by expert users. Please
consult with a qualified technician for installation. Improper installation
may result in damage to your equipment. EK Water Blocks assumes
no liability whatsoever, expressed or implied, for the use of these
products, nor their installation. The following instructions are subject
to change without notice. Please visit our web site at www. ekwb.com
for updates.
Before you start using this product please follow these basic guidelines:
Please carefully read the manual through before beginning with the
installation process!
Please use only the enclosed screws. Using inappropriate
screws may result in radiator puncture leading to leakage of
the cooling fluid.

- 3 -
TABLE OF CONTENT
CONTENTS OF THE PACKAGE 4
INSTALLING THE FAN DIRECTLY 5
INSTALLING THE FAN ON TO THE RADIATOR 6
CONNECTING THE FANS 6
SUPPORT AND SERVICE 8
SOCIAL MEDIA 8

- 4 -
CONTENTS OF THE PACKAGE
EK -Vardar 120/140 FANS 2-way fan splitter Radiator mounting screws
(UNC #6-32)
Self tapping mounting
screws
EK -Vardar 120/140 FANS 3-way fan splitter Radiator mounting screws
(UNC #6-32)
Self tapping mounting
screws
240/280 VERSION:
360 VERSION:

- 5 -
INSTALLING THE FAN DIRECTLY
Each of the fans has a different cable length, because every fan
is intended for a specific position on the radiator. The fan with the
longest cable should be positioned furthest away from the splitter
so that the shorter fan cables will reach the splitter perfectly.
Cable lenghts for different radiator versions:
A. 170mm
B. 300mm
C. 420mm
C B A
EK-Vardar fans can be mount directly into the chassis using enclosed
self-tapping fan screws (see sample photo).
Self-tapping
screw

- 6 -
INSTALLING THE FAN ON TO THE RADIATOR
EK-Vardar fans can be mounted onto the radiator using UNC #6-
32 mounting screws (as shown on the photo). Tighten the screws
evenly and do not use excessive force!
UNC #6-32 Screw
STEP 1
CONNECTING THE FANS
In order to connect the fans you may use the enclosed fan splitter
adapters to reduce the number of headers required.
STEP 1
Connect the female connectors of the fans to the male connectors
on the fan splitter cable.
240/280 VERSION
360 VERSION
Fan
connector
Fan splitter
cable

- 7 -
STEP 2
STEP 2
Connect the female splitter connector to a header located on
the motherboard or fan controller. Where possible use a header
designated for the CPU.
Fan Header

For assistance please contact:
http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SUPPORT AND SERVICE
SOCIAL MEDIA
discord.gg/zesFRJB