Electro-Harmonix Cock Fight Plus User manual

1
Cock Fight Plus
Wah and Talking Pedal with Fuzz
What happens when you mate our popular Cock Fight (Cocked Talking
Wah with Fuzz) with a foot controlled rocker pedal? You get the Cock
Fight Plus! The Cock Fight Plus can be switched between two types of
filters: a traditional wah pedal filter (“CRY”), or a formant filter (“TALK”)
that you can use to create vowel sounds. Vary the sweep of either filter
with the integrated foot pedal. The Cock Fight Plus also includes a FUZZ
section that can be added before or after the filter, or taken out of the
circuit entirely. Use the BOTTOM and BIAS controls to explore even more
tone shaping possibilities.
CONTROLS
ENTERING/EXITING BYPASS
Toggle between buffered bypass and effect mode by firmly pushing
the Cock Fight Plus pedal downward, in the toe direction, until you hear
a click from its footswitch.
Please Note: The Cock Fight Plus does not provide a visual indication
that it is in either effect or bypass mode or that it is powered up.
PLAYING THE COCK FIGHT PLUS
While in effect mode, rock your foot back and forth on the pedal to
sweep the filter and alter the tone of your instrument.
COCKING THE COCK FIGHT PLUS
You may find your tone is especially sweet at certain spots along the
pedal’s sweep. When you hit just the right spot, carefully remove your
foot from the pedal so that the tone remains fixed. This use of the pedal
is commonly referred to as a “cocked wah.”

2
VOL Knob
Use the VOL (volume) knob to adjust the master output volume.
CRY/TALK Toggle Switch
The “up” position selects the CRY setting. CRY simulates the type of
filter found in a typical wah pedal circuit. The “down” position selects the
TALK setting. This setting—as its name implies—produces throaty/vocal
vowel sounds.
FUZZ PRE/X/POST Toggle Switch
The PRE position places the fuzz before the filter. Use this position for a
more vintage Hendrix vibe. The position marked Xremoves the fuzz
entirely from the circuit. The POST position places the fuzz after the
filter and yields a more modern sound.
BOT Knob
The BOT (BOTTOM) Knob is a low frequency boost control that is
slightly above unity gain when set fully clockwise. Set this knob fully
counterclockwise to remove the BOTTOM circuit from the signal path.
TIP: When used with a bass guitar or other low frequency sources, the
BOTTOM adjustment can help retain the bottom end typically lost along
certain positions of the filter sweep.
TONE Knob
Use the TONE knob to vary the fuzz sound from dark to bright.
BIAS Knob
The BIAS knob controls the amount of bias voltage supplied to one of
the two transistors in the fuzz circuit. Turn the BIAS knob fully clockwise
to supply a nominal voltage to produce a “normal” fuzz sound. Turn the
bias control down (counterclockwise) to decrease the bias voltage to get
the so-called “dying battery” sound. This type of sound is characterized
by a decrease in sustain and by notes that get choked off as you play
with less force.
DRIVE Knob
Set the amount of fuzz with the DRIVE knob.

3
INPUT/OUTPUT/POWER/SPECS
INPUT Jack
This ¼” jack is the audio input for the Cock Fight Plus.
OUTPUT Jack
This ¼” jack is the audio output for the Cock Fight Plus.
POWER
Internal Battery Plug a cable into the INPUT jack to activate power
from the included internal 9V battery. When using battery power, unplug
the input cable from the input jack when the unit is not in use to avoid
running down the battery. The pedal’s battery may be left in or taken
out when the external AC Adapter is in use.
External 9VDC AC Power The power jack input (marked 9V) is
located next to the OUTPUT jack. Use a 9VDC AC Adapter capable of
delivering at least 50 mA of current to power the pedal. The inner ring of
the 9VDC AC Adapter must be negative, and the outer ring positive. You
may choose to obtain the optional Electro-Harmonix 9.6DC-200 power
supply, which is the same type of 9.6 Volts DC/200mA power supply as
used by Boss®& Ibanez®.
Please Note: Using the wrong adapter or a plug with the wrong polarity
may damage your Cock Fight Plus and void the warranty.
CHANGING THE BATTERY
1. We recommend the use of 9V alkaline batteries.
2. Locate the battery door on the underside of the pedal.
3. Push the tab of the battery door towards OPEN to unlock the door;
pull the door up until it locks into its open position.
4. Connect your new 9V battery to the wired battery connector.
5. Insert/slide the 9V battery into the battery holder compartment.
6. Push the battery door down and firmly snap it closed.
NOTES AND SPECIFICATIONS
The Cock Fight Plus utilizes a high quality buffered bypass.
Input Impedance: 1M
Nominal Output Impedance: 3k
Current draw: 30mA

4
WARRANTY INFORMATION
Please register online at http://www.ehx.com/product-registration or complete
and return the enclosed warranty card within 10 days of purchase. Electro-
Harmonix will repair or replace, at its discretion, a product that fails to operate
due to defects in materials or workmanship for a period of one year from date of
purchase. This applies only to original purchasers who have bought their product
from an authorized Electro-Harmonix retailer. Repaired or replaced units will then
be warranted for the unexpired portion of the original warranty term.
If you should need to return your unit for service within the warranty period,
please contact the appropriate office listed below. Customers outside the regions
listed below, please contact EHX Customer Service for information on warranty
repairs at [email protected] or [phone]. USA and Canadian customers:
please obtain a Return Authorization Number (RA#) from EHX Customer
Service before returning your product. Include  with your returned unit  a written
description of the problem as well as your name, address, telephone number, e-
mail address, RA# and a copy of your receipt clearly showing the purchase date.
United States & Canada Europe
EHX CUSTOMER SERVICE JOHN WILLIAMS
ELECTRO-HARMONIX ELECTRO-HARMONIX UK
c/o NEW SENSOR CORP. 13 CWMDONKIN TERRACE
55-01 2ND STREET SWANSEA SA2 0RQ
LONG ISLAND CITY, NY 11101 UNITED KINGDOM
Tel: [phone] Tel: [phone]
Email: [email protected] Email: [e-mail]
FCC COMPLIANCE
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment under FCC rules.