Elkay EWTLA8 1C Series Installation manual

97054C (Rev. C - 3/98)
EWTLA8,14,16*1C EWTLA14*2C LWTLA14,20*1C, 3C
PAGE 1
With FLEXI-GUARD®
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
FIG. 1
SEE FIG. 4 7
7
26
SEE FIG. 3
37
39
22, 23,
24, & 25
17, 18,
19, & 20
15 & 16
38
SEE FIG. 4
SEE FIG. 3
36 14 32
21
35
31
30
27, 28
29
13
34
33, 40, 41
40, 41

97054C (Rev. C - 3/98)
EWTLA8,14,16*1C EWTLA14*2C LWTLA14,20*1C, 3C
PAGE 2
FIG. 2
E = INSURE PROPER VENTILATION BY MAINTAINING 4" (102mm) (MIN.) CLEARANCE FROM CABINET LOUVERS TO WALL.
ASEGURE UNA VENTILACIÓNADECUADA MANTENIENDO UN ESPACIO E 4" (102mm) (MÍN.) DE HOLGURA ENTRE LA REJILLA DE VENTILACIÓN DEL MUEBLE Y LA PARED ASSUREZ-VOUS UNE BONNE VENTILATION EN GARDANT 4" (102mm) (MIN.) ENTRE LES ÉVENTS DE LENCEINTE ET LE MUR.
F = POWER CORD 4 FEET (1219mm) LONG
CABLE ELÉCTRICO DE 4 PIE (1219mm), DE LARGO CORDON DALIMENTATION 4' (1219mm)
G = ALT. ELECTRICAL OUTLET LOCATION
UBICACIÓN ALT. DE LA TOMA DE ELECTRICIDAD EMPLACEMENT ALTERNATIF DE LA PRISE DE COURANT
FINISHED FLOOR PISO ACABADO PLANCHER FINI
LEGEND/LEYENDA/LÉGENDE A = RECOMMENDED WATER SUPPLY LOCATION 3/8 O.D. UNPLATED COPPER TUBE CONNECT STUB OUT 1-1/2 IN. (38mm)
FROM WALL SHUT OFF BY OTHERS
SE RECOMIENDA UBICAR ELTUBO CORTO DE CONEXIÓNAL TUBO DE COBRE SIN CHAPAR DE 3/8" DE DIÁM. EXT. A1-1/2"
(38 mm) FUERA DE LALLAVE DE PASO EN LA PARED COLOCADA POR TERCEROS.
EMPLACEMENT RECOMMANDÉ D'ALIMENTATION EN EAU PAR TUBE EN CUIVRE NON PLAQUÉ DE 3/8 PO. (9,5 mm) D.E.
CONNECTANT UNE TUYAUTERIE DE 1-1/2 PO. (38 mm) DEPUIS LE ROBINET D'ARRÊT FOURNI PAR D'AUTRES.
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4 O.D. DRAIN
UBICACIÓN RECOMENDADA PARA EL DRENAJE DE SALIDA DE AGUA, DE 1¼ DE DIÁMETRO. EMPLACEMENT RECOMMANDÉ POUR LE DRAIN DE D.E. 1-1/4" DE SORTIE DEAU.
C = 1-1/4 TRAP NOT FURNISHED
PURGADOR DE 1¼ NO PROPORCIONADO SIPHON 1-1/4 NON FOURNI
D = ELECTRICAL OUTLET LOCATION
UBICACIÓN DE LA TOMA DE ELECTRICIDAD EMPLACEMENT DE LA PRISE DE COURANT

97054C (Rev. C - 3/98)
EWTLA8,14,16*1C EWTLA14*2C LWTLA14,20*1C, 3C
PAGE 3
FIG. 3 FIG. 4
NOTE:
WHEN INSTALLING REPLACEMENT BUBBLER
AND PEDESTAL, TIGHTEN NUT (ITEM 12) ONLY
TO HOLD PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
BASIN
9
10
11
12
8
Stream height is factory set at 35 PSI. If supply
pressure varies greatly from this, remove Items
1 & 2 and adjust screw on
Item 4. Clockwise adjustment will raise stream
and counter-clockwise adjustment will lower
stream. For best adjustment, stream should hit
basin approximately 6-1/2" (165mm) from
bubbler.
BASIN
4
3
1
5
6
2
When provided
1
6
7
2
43
5
ITEM NO.
Filter Head Assy
Screw #8-18 X .75 PH
Fitting - Superseal 3/8 (10mm)
Fitting - Superseal 1/4 (6mm)
Filter Assy
Elbow - 3/8 (10mm)
Bracket
1
2
3
4
5
6
7
51294C
70792C
70823C
70822C
51299C
70818C
22490C
DESCRIPTION
PART
NO.
DESIGN 2000®FILTER PARTS LIST

97054C (Rev. C - 3/98)
EWTLA8,14,16*1C EWTLA14*2C LWTLA14,20*1C, 3C
PAGE 4
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620
ELKAY MANUFACTURING COMPANY  2222 CAMDEN COURT  OAK BROOK, IL 60523  630.574.8484
PRINTED IN U.S.A.
PARTS LIST 115V
ITEM NO. PART NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22*
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
NS
NS
31438C
31430C
35764C
31028C
35768C
14
17
22*
23
24
Power Cord
Fan Motor
Compressor Serv. Pak
Overload/Relay Assy
Relay Cover
PART. NO. DESCRIPTIONITEM NO.
220V/50Hz
40089C
40048C
15005C
61313C
40169C
50986C
20776C
51349C
40322C
50934C
50168C
70012C
31513C
31502C
35885C
66431C
66417C
66432C
21516C
31490C
31491C
31492C
30664C
20239C
70018C
66201C
66202C
66203C
35787C
35762C
35744C
35775C
31034C
31027C
31029C
35840C
35843C
35766C
194243901550
55996C
45693C
55909C
66255C
66229C
66256C
66445C
66421C
66420C
70836C
40022C
40088C
See Color Table
See Color Table
See Color Table
See Color Table
See Color Table
See Color Table
50005C
70016C
70767C
70772C
Cover
Button
Regulator Retaining Nut
Regulator
Hex Nut
Regulator Holder
Basin
Bubbler Assy
Orifice Assy
Housing Assy
Pedestal
Bubbler Locknut
Cold Control
Power Cord (8,14,& 16 GPH)
Power Cord (20 GPH)
Condenser (8 GPH)
Condenser (14 & 16 GPH)
Condenser (20 GPH)
Fan Shroud
Fan Motor (8 & 14 GPH)
Fan Motor (16 GPH)
Fan Motor (20 GPH)
Fan Blade
Fan Bracket
Fan Blade Nut
Drier (8 GPH)
Drier (14 GPH)
Drier (16 & 20 GPH)
Compressor Serv. Pak 8 GPH
Compressor Serv. Pak 14 GPH
Compressor Serv. Pak. 16 GPH
Compressor Serv. Pak. 20 GPH
Overload/Relay Assy (8 GPH)
Overload/Relay Assy (14 GPH)
Overload/Relay Assy (16 GPH)
Overload (20 GPH)
Relay (20GPH)
Relay Cover
Electrical Shield
Strainer
Precooler
Tailpipe Helix
Heat Exchanger (8 GPH)
Heat Exchanger (14 GPH)
Heat Exchanger (16 GPH)
Heat Exchanger (20 GPH)
Evaporator (8 & 14 GPH)
Evaporator (16 & 20 GPH)
Reducing Elbow 3/8 to 1/4
Waste Connection Assy
Assy - Tailpipe
Panel-Left Side (Right Unit)
Panel-Right Side (Right Unit)
Panel-Front (Right Unit)
Panel-Left Side (Left Unit)
Panel-Right Side (Left Unit)
Panel-Front (Left Unit)
Gasket - Tailpipe
Nut - Hex
Evaporator Retaining Clip
Evaporator Drain Plug
DESCRIPTION
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, RE-
PLACE WITH SAME COMPRESSOR USED IN ORIGINAL ASSEM-
BLY.
NOTE: All correspondence pertaining to any of the above water
coolers or orders for repair parts MUST include Model No. and
Serial No. of cooler, name and part number of replacement part.
Item No. 34
Part No.
COLOR TABLE
Gray Beige
Almond
Stainless Stl
Sandalwood
Granite
20639C
21465C
20641C
21463C
27174C
20675C
20676C
20672C
21454C
27150C
PANEL
COLOR
Item No. 35
Part No.
Item No. 37
Part No.
Item No. 38
Part No.
Item No. 36
Part No.
20646C
21468C
20648C
21466C
27177C
20736C
21479C
20737C
21478C
27189C
Item No. 39
Part No.
20684C
20685C
20681C
21456C
27153C
20732C
21477C
20733C
21476C
27186C
Gray Beige
Almond
Stainless Stl
Sandalwood
Granite
PANEL
COLOR
COLOR TABLE
31438C
31431C
35856C
35799C
35805C
14
17
22*
23
23
Power Cord
Fan Motor
Compressor Serv. Pak
Overload
Relay
PART. NO. DESCRIPTIONITEM NO.
230V/60Hz