Elto ETRBSS User manual

OPERATING INSTRUCTIONS
HEATED TOWEL RAIL
ETRBSS / ETRBW
220-240V, 45W, IPX1

SAFETY INFORMATION
When using any electrical appliance, basic safety precautions should always be
observed.
READ THESE INSTRUCTIONS CAREFULLY. Keep them handy for future reference.
This appliance is intended to warm and dry towels and therefore is hot to the touch.
When used by or near young children or infirm persons, close supervision is
necessary. Young children should be supervised to ensure that they do not play with
the appliance.
Any rise in ambient temperature is directly reflected in the appliance, and as a result
of this, the appliance will feel hotter to the touch during warmer periods. Also the
insulation effect of towels will cause the operating temperature to increase slightly.
The appliance is to be installed so that switches and other controls cannot be
touched by a person in the bath or shower.
Do NOT use this appliance for any purpose other than its intended use.
To avoid a hazard this heated towel rail MUST NOT be used to carry towels or any
other articles that have been in contact with oil, petroleum based products or dry
cleaning fluids.
Use this appliance only with the voltage specified on the rating label, or elsewhere in
these instructions.
Regulations require that electrical work be carried out only by authorised persons.
This product must be used in conjunction with a hard wired switch.
For your own safety and that of others ensure this is done.
DO NOT immerse in any liquid.
For service contact your nearest Authorised Service Agent.
Means of disconnection must be incorporated in fixed wiring for permanently wired
towel rails.
SPECIFICATIONS
DIMENSIONS
Model: ETRBSS / ETRBW
Height: 535mm
Width: 540mm
ELECTRICAL
Wattage, Painted –White: 45W
Stainless Steel: 45W
Power supply: 230 ~ 240 Volts a.c.
International Protection Rating: IPX1

CARE AND CLEANING
The Heated Towel Rail is best wiped down from time to time with a damp cloth.
DO NOT USE ANY ABRASIVE OR CORROSIVE CLEANERS.
INSTALLATION

ELECTRICAL INSTALLATION
This appliance MUST be installed in accordance with the relevant wiring rules and
regulations and in particular those regulations which cover installation of appliances and
accessories in damp situations such as bathrooms, showers, laundries and other areas
with fixed water containers. It is to be fitted in accordance with applicable
Australian/New Zealand standards (AS/NZS).
In accordance with New Zealand’s wiring regulations this appliance is required to be
connected to a power supply that includes an earth circuit.
This appliance cannot be connected to a two wire (lighting) power circuit.
WARNING:In order to avoid a hazard for young children, this appliance must be
installed so that the bottom rail is at least 600 mm above the floor.
Special purpose tools are required for the replacement of the power supply cord.
Contact an Authorised Service Agent for service.
Please note that if mounting your Heated Towel Rail yourself contact your local
hardware professional for advice on the best mounting hardware for your walls, as this
may vary.
MOUNTING
Choose a suitable position on the wall to mount the Heated Towel Rail. The flex entry
must be horizontal and at the bottom of the frame.
Fit the leg brackets shown in figure 1.
Place the Heated Towel Rail on a flat surface, check that all the leg brackets are sitting
parallel, if not parallel, re-tightening may be required. Do not over tighten or parts of the
towel rail may break.
Line up the towel rail on the wall, screw the lugs onto the wall in the correct positions.
Place the legs over the lugs and tighten the grub screws to ensure the towel rail stays in
position on the wall.
SUPPORTAND TECHNICALADVICE
North Shore City, Auckland, New Zealand
Monday –Friday 8am-5pm
Phone: [phone]
Website: www.cdb.co.nz

Your Elto product has been inspected and tested and is guaranteed subject to the
following for a period to One year from the date of purchase against defects in
workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Elto product fails to operate satisfactorily, please return it to the retailer from
whom it was purchased. To obtain a repair or replacement product under this
warranty, you will need to produce satisfactory evidence of date of purchase. The
completed warranty and purchase receipt must be presented with the product. The
warranty should be filled out at the time of purchase. It is in your interest to make
sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be of
the same or similar product or accessory excluding packaging, instruction card etc.
Where a replacement product is supplied, this shall be guaranteed for the balance of
the original warranty period.
Any model that is no longer available will be replaced by a model of a value and with
such features as we consider appropriate in the circumstances. Elto Ltd is not
responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation, then
that provision shall be deemed to be excluded from the warranty and the rest of the
provisions will continue to apply.
ONE YEAR WARRANTY
IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD
NAME:
ADDRESS:
PURCHASED FROM:
SUBURB:
DATE OF PURCHASE:
NAME OF PRODUCT:
MODEL No: