eMitter DC1600A User manual

DC1600A
Emitter Specification
DC1600A DC1600A Back
Type specification
T
Setting button
Up button
Stop button
Down button
Version NO. : A/01
Lamp cont-
rol button
Fucntion instructionTechnical specification
Input voltage：3V(CR2450)
Transmitting frequency：433MHz
Transmitting power：10 milliwatt
Operating temperature：-100C—500C
Transmitting distance：200 meters open office，
35 meters on two walls
Transmitter: you can choose single channel (DC1600A), Lamp control can
cycle switch, open or close the light bulb
Notice: transmitter do not exposed to moisture and strike, so as not to affect life.
When you use transmitter, if found emission distance obviously short or less sensitive,
please change another same new battery. Please have batteries for recycling.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS

(Setting button)×1
During the settings,the time between
two operation must be shorter than
4s,otherwise it will quit the setting
A
Additional
function
Matchable R tubular motor setting up
Power on
Sound from motor
hear long sound
Up×1
Down×1
OK
OK
Delete all the datas of the motor and
the new emitter has been programmed.
Beep once Beep once
Set up is ok.
The up button control
the motor clockwise
Set up is ok.
The down button control
the motor clockwise
Run or beep
for hint
Run or beep
for hint
(Setting button)×1
A
Additional
function
Lamp control(Only workable for receiver with lamp control)
OK
Power on Press Lamp cont-
rol button once
Press Lamp cont-
rol button once
Lamp on Lamp off
Press the lamp control button
circularly to switch the lamp
on and off circularly