Empire DVLL36 Series User manual

37101-6-0620 Page 1Empire Comfort Systems Inc. • Belleville, IL
FOR USE ON MODELS: DVLL(36,48,60,72)BP,SP SERIES FIREPLACES ONLY
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
DECORATIVE FRAME MODELS
DVLL36 DVLL48 DVLL60 DVLL72
DFF36LFPD DFF48FPD DFF60FPD DFF72FPD
DFF36LBL DFF48LBL DFF60LBL DFF72LBL
DFF36LBZT DFF48LBZT DFF60LBZT —
CLEANING
With the unit turned off and cool to the touch, use a 50/50
solution of vinegar and water and a clean soft cloth to
remove dirt and ngerprints. Clean frame before and
after start-up and again anytime oil or ngerprints are
present. When heated, oil from ngerprints or left over from
manufacturing can permanently discolor the plating.
TOOLS NEEDED:
• Phillips Screwdriver
INSTALLATION
1. Remove the replace barrier screen assembly. Lift up
the barrier screen approximately 3/8 inch, then pull
forward to remove it from the replace.
2. Install on front bracket per side with two #8 x 1/2-inch
screws each. See Figure 1.
Figure 1
3. Reinstall the barrier screen assembly.
4. Insert the extended bracket tabs on the rear of the
Forged Iron Decorative Front into the front brackets
installed in Step 2. See Figure 2.
Figure 2
5. Installation is complete. See Figure 3.
Figure 3
INSTALLATION INSTRUCTIONS
DECORATIVE FRONTS

37101-6-0620Page 2
www.empirecomfort.com
Empire Comfort Systems Inc.
Belleville, IL
If you have a general question
about our products, please e-mail
us at [email protected].
If you have a service or repair
question, please contact your dealer.