emulait STARTER KIT Operator's manual

USER INSTRUCTION MANUAL
STARTER KIT

Classic bottle
Anatomy bottle
Lids x 2 Caps x 2 Nipples x 2 Flow Controls x 3
(slow, medium, fast)
Classic bottle
base
Anatomy bottle
base
Brush
What’s Included
Remove nipple and base
Fully Disassemble for Cleaning
1Remove Flow Control
2
Push down on nipple
to pop out the Flow Control

Before First Use
Clean hands and surfaces thoroughly before handling.
Disassemble all products and sterilize each part in
boiling water for about five minutes. Let all parts cool
until they are no longer warm to the touch. To ensure
hygiene, check that there is no remaining water inside
the bottle or nipple before use.
Cleaning and Sterilizing
Clean hands and surfaces thoroughly before handling.
Fully disassemble all parts. Wash all parts in hot water and
soap. Rinse and dry thoroughly, ensuring all cavities are
clean and clear.
All parts are dishwasher safe (top rack only), and safe for
use in an eletric sterilizer, microwave sterilier or boiling
water. Use chemical/sterilizing solutions or sterilizers
strictly according to the manufacturer’s instructions.
Steam can cause severe skin burns, use caution when
boiling on the stove or using any sterilizing equipment.
Avoid unnecessary handling of sterilized items and
equipment.
For Your Child’s Safety and Health
Always check food temperature before feeding.
• Throw away at the first signs of damage or weakness.
• Keep components not in use out of the reach of children.
• Remove from your baby’s mouth when the baby is not feeding.
• Always use this product with adult supervision.
• Always check the nipples/teats for signs of wear and replace when
damaged.
• Do not use a microwave oven to heat the bottle as microwave
ovens can create hotspots in milk/formula and/or bottle
components.
• The bottle components are not toys and should not be given to
children to play with or suck on.
Flow Control
Emulait Nipples are designed to be used with a Flow Control. The
Emulait Starter Kit comes with slow, medium and fast milk flow rate
controls. Choose desired flow rate and insert into the Emulait
Nipple before use. Flow Control must be inserted in nipple while in
use to prevent collapse.
WARNING!
Classic bottle
How to Hold Bottle How to Insert Flow Control
Anatomy bottle 1. Clean hands and surfaces thoroughly before
handling.
2. Hold the Flow Control with the fibers facing
towards the nipple cavity.
3. Place the Flow Control into the Emulait Nipple
and push gently until it pops into place.
4. To ensure Flow Control is sealed, use your
finger to smooth around the inner edges and
secure in place.

Yours Truly