Enable-IT 8805 User manual

All Rights Reserved 1997 - 2015 ENABLE-IT - Proprietary and Confidential
Enable-IT 8805 Gigabit PoE Switch
Quickstart Guide

All Rights Reserved 1997 - 2014 Enable-IT, Inc. Page 2 of 6
INSTALLING THE 8805 GIGABIT POE SWITCH
The Enable-IT 8805 Gigabit PoE Switch is a unique product. It can automatically detect
any LAN device and determine if it is a PoE device and supply power with IEEE 802.3af
standard voltage and watts.
The Enable-IT 8805 Gigabit PoE Switch is a 5 port 10/100/1000Mbps Auto-Negotiation
RJ-45 LAN ports with each port PoE auto detect enabled. Auto detect PoE uses IEEE
802.3 PoE PD. There is no need to worry about the damage of PoE being applied to
Non-PoE Devices and PoE connected devices are supplied with up to 30W per port. The
Enable-IT 8805 supplies PoE electrical power on industry standard 2-pair (RJ-45 pins 4/5
positive and 7/8 negative) along with Ethernet data in one single cable allowing you to
expand your network where there are no power lines or outlets. This enable you to deploy
PoE devices such as WiFi Access Points, PoE IP Cameras, Poe Access controls or PoE
IP Phones.
FEATURES
(5) 10/100/1000Mbps Auto-Negotiation RJ-45 ports with PoE auto detect
Complies with IEEE802.3af standards
Each port supports full duplex auto-negotiation -10/20, 100/200, 1000/2000Mbps
Maximum Bandwidth backplane 10Gbps
Supports PoE power up to 30W for each PoE port
Supports automatic-detect function to protect the system when the system power is
overloaded or there is a non-PoE device
LED indicators for monitoring PoE power, Physical link, LAN activity and LAN speed
48V 2A power adapter included
PACKAGE
(1) Enable-IT 8805 (5) port Gigabit PoE switch
48V 2A DC power adapter, power cord
Enable-IT 8805 Quickstart Guide

All Rights Reserved 1997 - 2014 Enable-IT, Inc. Page 3 of 6
TECHNICAL SPECIFICATIONS
Standards & Protocols:
IEEE802.3, 802.3u, 802.3af, 802.3x
CSMA/CD, TCP/IP
Basic Function:
Wire-speed Performance
MAC addresses Auto-Learning and Auto-aging
IEEE802.3x flow control for Full-Duplex Mode and
backpressure for Half-Duplex Mode
Backplane Bandwidth:
10Gbps
Power Support:
Max power: 30W for each PoE port
48V 2A Power adapter
Transmission Method:
Store-and-Forward
Ports:
10/100/1000Mbps Auto-Negotiation RJ-45 PoE ports
(Auto MDI/MDIX)
Network Media:
10Base-T:UTP category 3, 4, 5 cable (maximum 100m)
EIA/TIA-568 100U STP (maximum 100m)
100Base-Tx: UTP category 5, 5e cable (maximum 100m)
EIA/TIA-568 100U STP (maximum 100m)
1000Base-T: UTP category 5, 5e cable (maximum 100m
LED Indicators:
PoE Power
Physical Link
LAN Activity,
LAN Speed (10/100/1000Mbps)
Safety & Emission:
FCC, CE, RoHS
Environment:
Operating Temperature: 0
C ~ 50 C
Storage Temperature: -10
C ~ 70 C
Operating Humidity: 10%~90% non-condensing
Storage Humidity: 5%~90% non-condensing
Dimensions:
Length 4.09in (104mm)
Width 3.58in (91mm)
Height 1.10in (28 mm)
Security Standard:
CE/LV
Warranty Period:
4 years

All Rights Reserved 1997 - 2014 Enable-IT, Inc. Page 4 of 6
ENABLE-IT, INC. LIMITED WARRANTY
Enable-IT, Inc. warrants the Enable-IT 8805 Gigabit PoE Switch solely pursuant to the
following terms and conditions.
1. PRODUCT WARRANTY.
a. Express Warranty.
Enable-IT warrants to the original purchaser of the Product ("you" or the "End User") that, for
the four (4) year period commencing on the date the Product was purchased (the "Warranty
Period"), the Product will be substantially free from defects in materials and workmanship
under normal use and conditions. This warranty does not apply to Products, which are resold
as used, repaired or reconditioned, or consumables (such as batteries) supplied with the
Product. Electrical damage is not an item that is covered under this warranty or
extended warranties. Enable-IT does not make any warranty with respect to any third party
product, software or accessory supplied with or used in connection with the Product and such
third party products, software and accessories, if any, are provided "AS IS." Warranty claims
related to such third party products, software and accessories must be made to the applicable
third party manufacturer.
b. Remedies for Breach of Warranty.
In the event of a breach of the foregoing warranty, Enable-IT will, in its sole discretion and at its
cost, and subject to the terms of the following paragraph, repair the non-conforming Product,
replace the non-conforming Product with a new or reconditioned Product or refund the
purchase price for the Product. Any new or reconditioned Product provided pursuant to this
paragraph is warranted as provided herein for the remainder of the original Warranty Period.
THE REMEDY SET FORTH IN THIS PARAGRAPH SHALL BE THE END USER’S SOLE
AND EXCLUSIVE REMEDY FOR BREACH OF THE FOREGOING WARRANTY.
c. Conditions for Warranty Qualification.
If authorized by Enable-IT to return a Product which does not conform to the warranty set forth
above, the End User must: (1) obtain a return materials authorization (RMA) number from
Enable-IT by contacting the Customer Service Dept. at 888-309-0910 between the hours of
8:00 a.m. and 5:00 p.m. PST and otherwise fully comply with Enable-IT’s then-current RMA
policy; (2) return the Product to Enable-IT in its original packaging freight pre-paid; and (3)
provide to Enable-IT the original receipt or bill of sale establishing the date on which the Product
was purchased. Products returned to Enable-IT without an RMA number will be returned to the
End User. Enable-IT shall not be responsible for damage or loss during shipment of the
returned Product to Enable-IT.
d. Voiding of Warranty.
The express warranty set forth above shall not apply to failure of the Product if the Product has
been subjected to: (i) physical abuse, misuse, improper installation, abnormal use, power
failure or surge, or use not consistent with the operating instructions provided by Enable-IT; (ii)
modification (including but not limited to opening the Product housing) or repair by any party in
any manner other than as approved by Enable-IT in writing; (iii) fraud, tampering, unusual
physical or electrical stress, unsuitable operating or physical conditions, negligence or
accidents; (iv) removal or alteration of the Product serial number tag; (v) improper packaging of
Product returns; or (vi) damage during shipment (other than during the original shipment of the
Product to the End User from Enable-IT, if applicable).

All Rights Reserved 1997 - 2014 Enable-IT, Inc. Page 5 of 6
e. Warranty Disclaimers.
THE EXPRESS WARRANTY SET FORTH ABOVE IS IN LIEU OF ALL OTHER
WARRANTIES, WHETHER WRITTEN, ORAL, EXPRESS OR IMPLIED. ENABLE-IT
DISCLAIMS, TO THE MAXIMUM EXTENT PERMITTED BY LAW, THE IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR
NONINFRINGEMENT OF THIRD PARTY RIGHTS. NO PERSON (INCLUDING WITHOUT
LIMITATION, ENABLE-IT’S EMPLOYEES, AGENTS, RESELLERS, OEMS OR
DISTRIBUTORS) IS AUTHORIZED TO MAKE ANY OTHER WARRANTY OR
REPRESENTATION CONCERNING THE PRODUCT. IF THE DISCLAIMER OF ANY
IMPLIED WARRANTY IS NOT PERMITTED BY LAW, THE DURATION OF ANY SUCH
IMPLIED WARRANTY IS LIMITED TO ONE (1) YEAR FROM THE DATE OF PURCHASE.
SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES
OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY MAY LAST, SO SUCH
LIMITATIONS OR EXCLUSIONS MAY NOT APPLY. THIS WARRANTY GIVES THE END
USER SPECIFIC LEGAL RIGHTS AND THE END USER MAY ALSO HAVE OTHER
RIGHTS, WHICH VARY FROM JURISDICTION TO JURISDICTION. ENABLE-IT DOES
NOT WARRANT THAT THE OPERATION OF THE PRODUCT WILL BE UNINTERRUPTED
OR ERROR FREE. ENABLE-IT IS NOT RESPONSIBLE FOR ANY DAMAGE TO OR LOSS
OF ANY PROGRAMS, DATA, OR OTHER INFORMATION STORED ON OR
TRANSMITTED USING THE PRODUCT.
2. LIMITATION OF LIABILITY.
IN NO EVENT SHALL ENABLE-IT BE LIABLE TO THE END USER, OR ANY THIRD PARTY,
FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL
DAMAGES IN CONNECTION WITH OR ARISING OUT OF THE SALE OR USE OF THE
PRODUCT (INCLUDING BUT NOT LIMITED TO LOSS OF PROFIT, USE, DATA, OR
OTHER ECONOMIC ADVANTAGE), HOWEVER IT ARISES, INCLUDING WITHOUT
LIMITATION BREACH OF WARRANTY, OR IN CONTRACT OR IN TORT (INCLUDING
NEGLIGENCE), OR STRICT LIABILITY, EVEN IF ENABLE-IT HAS BEEN PREVIOUSLY
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND EVEN IF A LIMITED REMEDY
SET FORTH IN THIS AGREEMENT FAILS OF ITS ESSENTIAL PURPOSE. IN NO EVENT
SHALL ENABLE-IT’S LIABILITY TO THE END USER, OR ANY THIRD PARTY, EXCEED
THE PRICE PAID FOR THE PRODUCT. BECAUSE SOME JURISDICTIONS DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR
INCIDENTAL DAMAGES, THE ABOVE LIMITATIONS MAY NOT APPLY TO THE END
USER.
3. LICENSE AND LIMITATIONS.
The firmware and software embedded in the Product (the "Embedded Software") are licensed
to you. Your use of the Product is your acceptance of the warranty terms above and the terms
below. You may use the Embedded Software solely in conjunction with your use of the Product.
All worldwide right, title and interest in and to the Product, or any portion thereof (including but
not limited to the Embedded Software), including all copyrights, patent rights, trademarks, trade
secrets, and other intellectual property rights therein and thereto, are and shall remain the
exclusive property of Enable-IT and/or its licensors. You acknowledge and agree that you may
not, and may not allow any third party to, (i) use the Embedded Software in a manner that is
inconsistent with the above express right granted to you or (ii) modify, distribute, reproduce,
decompile, disassemble, reverse engineer or otherwise attempt to discover the source code for
the Embedded Software.

All Rights Reserved 1997 - 2014 Enable-IT, Inc. Page 6 of 6
CONTACT US
Sales and Customer Care:
Toll Free US and Canada 888 309-0910
866 389-8605 Fax
Other International [phone]
[phone] Fax
E Mail [e-mail]
[e-mail]
RMA Support:
http://support.enableit.com