Enabling Technologies Monique Manual

[2]
Initial Assembly
Parts List & Tools
Your Monique comes partially
assembled. You will need an M6 Allen
to finish assembly. Your ski will come
with a frame, seat, footrest, handle,
shock, gas struts as well as any
additional spare parts you ordered.
For Steps 1-6 please also see the
Initial Assembly Video on the product
manuals page of our website.
1) Shift the Lever to the “Up”
position and pull the A-Arms
down.
2) Install the Gas Struts.
The left and right Gas Struts have
been labelled with corresponding red
and green stickers.
Remove the stickers and the lock
pins from the Ball Sockets.
Thread the Gas Struts into the
Eyelets on the Frame.
Snap the Ball Sockets onto the
Ball Studs.
Secure the Lock Pins onto the Ball
Sockets.
3) Remove the rear Shock Bolt
and Shock Spacers.
You will need an M6 Allen.

MONIQUE
[3]
4) Remove the front Shock
Bolt.
Shift the Lever to the “Load / Ski”
position and push the A-Arms up to
expose the front Shock Bolt in the
Rocker Link. You will need an M6
Allen.
5) Install the front eyelet of
the Shock.
Feed the Shock into the Rocker Link
from the back side of the Load Link.
The rebound knob must face down.
Fasten with an M6 Allen.
6) Install the rear eyelet of the
Shock to the Load Link.
Pull the A-Arms down to align the
rear eyelet. Install the Shock Spacers
between the Shock and the Load Link
with the wide side of the flanges
facing out.
7) Compress the Monique into
the lowered skiing position.
Compress with the Shifter Lever in
the “Load / Ski” position.

[4]
8) Set up the Seat.
See the image to the right for proper
setup.
The waist has two pads secured
with a ratcheting V-ladder.
The thigh has one pad secured
with a single ratcheting ladder
The seat angle adjustment has
two extension buckles at the
front of the thighs secured to two
single ratcheting ladders from the
seat back.
9) Remove and discard the
wooden dowels from the foot
and handle tubes.
The pin does not go through the
dowel. Remove the dowel first and
then remove the pin.
10) Install the Footrest.
Be careful to slide each side in
straight and at the same time. Slide /
tap the footrest into the tubes. If
necessary, a rubber mallet can be
used to overcome initial friction. If
necessary, tighten the ankle angle
adjustment clamps.
11) Install the handle.

MONIQUE
[5]
