Enclume FPTS17S User manual

FPTS17S-HEARTHSIDE TOOL SET – SMALL
Enclosed you will find everything needed for the assembly
and use of your tool set.
The parts and hardware included are:
Components included:
1 - Arched Upright with Slots
2 - Back Leg Supports
1 - Broom
1 - Poker
1 - Shovel
Hardware included:
2 - ¼” x ½” Button Head Screws
1 - 5/32” Hex Key
See reverse side for ASSEMBLY INSTRUCTIONS
Thank you for choosing Enclume!
Enclume racks are the ultimate quality,
design, strength and function.
WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR
RACK
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone] Fax [phone]
www.enclume.com

ASSEMBLY INSTRUCTIONS
RACK ASSEMBLY
1) Place the arched upright on a flat surface with the two bends, which form the two front leg supports,
pointing down.
2) Attach the two back leg supports to the arched uptight opposite the front leg supports using the 1/2'”
button head screws. Insert the button head screws through the front of the arched upright and into the
back leg supports using the hex key wrench supplied.
4) Note: The screw holes in the back leg supports are threaded so they must receive the button head
screws last.
5) Square up your tool set and tighten the button head screws using the hex key.
6) Hang the three tools in this set on the notches in the arched upright. Your rack is now complete.
It is important that your tool set is assembled correctly. If the set is assembled or
used incorrectly, it could become unstable and collapse, possibly causing injury.
Also natural broom straw is flammable. So you must keep the broom well away
from open flame. And for sure it should not be used to sweep hot coals or ash.
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five year from the date of purchase. Your exclusive remedy is the repair
or replacement of the defective product, which is subject to the following conditions: (1) Your written notice of any defect is received by Enclume within the
warranty period, and (2) You return the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20 days
following your receipt of a return authorization number from Enclume (which number may be obtained by telephoning the number below).
There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PORPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE
PURCHASE OR USE OF THS PRODUCT.