Enclume Lr1a User manual

LR1A and LR1B-Rectangular Firewood Rack

LR1A

Enclosed you will find everything needed for the assembly

and use of your storage rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

6 – 3/8” x 5/8” Button head screws

1 – 7/32” Allen wrench

4 – Hard Glides

Components included:

2 – Uprights

2 – Legs

2 – Kindling Holders

LR1B

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100 Fax 360-385-6156

www.enclume.com

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Hard Glides

Rack Assembly:

1) Slip the floor glides over the end of the legs.

2) Align the two upright body pieces so the two kindling holders are at the same end.

3) Place the uprights on top and perpendicular to the legs. Using the Allen wrench and the four 3/8” x

5/8” button head screws, attach the legs and the uprights together. The screws should be inserted from

the top down toward the floor. Tighten the screws only finger tight.

4) Attach the two kindling holders to the uprights using the 3/8” x 5/8” button head screws

5) Square up your rack and tighten all the screws firmly.

It is important that your rack is assembled correctly. If the unit is assembled or

used incorrectly, it could become unstable and collapse, possibly causing injury

WARNING

Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall

be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the

warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20

days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by