ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rack Assembly
1) Push Hard Glides onto the ends of each leg.
2) Place each leg approximately 12” apart and parallel to each other.
3) Set uprights perpendicularly on top of the legs, lining up holes attach with the four 3/8” x 5/8” button head screws, tighten only
finger tight.
4) Place tool bar across the top outside of the uprights, making sure the hooks are facing upward. Secure into place using the
remaining (2) 3/8” x ½” button head screws, going from the outside of the tool bar thru the inside of the uprights. Again, leave
screws finger tight.
5) Square up your rack and tighten all button head screws using the Allen wrench included in the hardware. The assembly of your
rack is now complete.
It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
Natural broom straw is flammable. Keep the broom well away from open flame. It should not
be used to sweep hot coals or ash.
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall
be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20
days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by
Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.
