Enclume HDR3 Instruction manual

Boot and Mitten Drying Rack
ModelHDR3
WARNING:
The parts and hardware included are:
Hardware parts:
6 – 5/16"x 1/2"Button Head Screws
4 – 5/16"x 3/8"Button Head Screws
1 – 3/16"Allen Wrench
4 – Hard Glides
Components:
2 – Legs
2 – Boot Holders
2 – Uprights
1 – Upper Crossbar
4 – Accessory Hooks
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
Assembly and Installation Instructions for the Hearth Drying Rack HDR3
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Your exclusive remedy shall be
the repair or replacement of the defective product, which shall be subject to the following conditions: (1) Your notice of a defect is received by Enclume within the
warranty period, and (2) your return of the defective product to Enclume Design Products (24 Colwell St. , Port Hadlock, WA 98339) postage prepaid within 20
days following your receipt of a return authorization number from Enclume (which may be obtained by telephoning the number at the bottom of these instructions).
There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, AND ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF
THE PURCHASE OR USE OF THIS PRODUCT.
Enclume racks are the ultimate in Quality,
design, strength and function. Congratulations
for owning one of the finest storage racks
made.
Enclosed your will find everything needed
for the assembly and use of your hearth
rack.
READ ALL OF THE INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR RACK.
If you need help, please call 1-877-362-5863 or email
[email protected].

Rack Assembly: (Please note: Do not tighten the screws completely until rack is fully assembled)
1) Locate the legs and insert each end into one of the 4 hard glides. Then place the legs on the floor hard
glides down.
2) Place a boot holder cross wise on one end of the legs, align the holes and with the 5/16"x 1/2"button
head screws, attach to legs. Repeat on the other side.
3) Place one upright cross wise on one of the center holes with the L facing out and the tall side in the
center. Attach with one of the 5/16"x 1/2"button head screws. Repeat on the other side.
4) Place Top Cross bar between the 2 uprights and place the 5/16"x 1/2"button head screw through both
uprights and the cross bar.
5) Attach the 4 accessory hooks (2 on each side) with the 5/16"x 3/8"button head screws.
6) Square up the rack and tighten the screws securely.
7) Our hammered steel racks are finished with an industrial wax designed to give years of protection to the
rack. Cleaning is easily done with a damp cloth. Dry thoroughly after cleaning. If a touch-up is ever
needed we recommend a commercial wax product.
WARNING
It is important that your rack is assembled correctly. If the unit is assembled
or used incorrectly, it could become unstable and collapse, possibly causing
injury. Please use caution when drying clothing near a fire source. Fabrics
are combustible and could ignite.
Enclume Designs LLC •24 Colwell Street •Port Hadlock, WA 98339 •360.385.6100 • www.enclume.com