Enclume LR2tr Instruction manual

LR2tr
Retro Fit Tools Kit for LR2 Sling Rack
Enclosed you will find everything needed for the assembly
Of your firewood rack. Two people make assembly easier
The parts and hardware included are:
1 Tool holder 1 – Shovel
1 Poker 2 – 3/8” x 3/4” Button head screws
1 Broom 1 – 7/32” Allen wrench
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
Limited Warranty:This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall be
the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the warranty
period and (2) customer returns the defective product to Enclume Design Products, Inc. , 24 Colwell St.. , Port Hadlock, WA 98339, postage prepaid within 20 days
following a return authorization number (which may be obtained by telephoning the number at the bottom of this instructions) being provided to the customer by
Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA. 98339
Phone [phone] Fax [phone]
www.enclume.com
Your LR2 Sling rack is one of the finest wood storage racks made.
Enclume’s unique surface treatment gives our solid steel firewood
racks a rich patina and hammered appearance unequaled in depth
and texture. The rack surfaces have been finished to resist
corrosion and let the natural beauty of the gray carbon steel shine
through. If your rack is used outdoors, rust or corrosion may occur.
To prevent this, we recommend indoor use.
WARNING:
READ ALL OF THE INSTRUCTIONS
BEFORE MODIFYIING AND USING
THE RACK

Assembly and Installation Instructions
to modify your LR2 rack to become an LR2tr
Enclosed you will find everything needed for the assembly
of your tool retrofit kit. The parts and hardware included are:
1 Tool holder 1 Shovel
1 Poker 2 – 3/8” x 3/4” Button head screws Tool Holder
1 Broom 1 – 7/32” Allen wrench Button head screws
ASSEMBLY INSTRUCTIONS
1) Using the Allen wrench, remove the button head screw from one side of each upright to detach the
kindling holder. Discard the screws. Loosen but do not remove the screws on the opposite side.
2) Attach the tool holder to the outside of the rectangular piece by inserting the ¾” screw from the outside,
through the tool holder, the upright and into the kindling holder. Repeat on the other side. Tighten the
screws only finger tight.
3) Square up the rack and tighten all screws.
4) Hang the tools on the tool holder hooks.
5) Use the kindling holder for kindling only. DO NOT stack logs in the kindling holder.
6) To clean your rack, use a damp cloth and dry it thoroughly. If a touch-up is ever necessary, remove any
dirt or rust with steel wool and re-coat with a “Pledge” like wax product.
It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA. 98339
Phone [phone] Fax [phone]
www.enclume.com
WARNING