ENERAMA Pyramid Garden Manual

Safety & Setup Instrucons
- Do not plug or unplug unit in wet or damp condions
- Always unplug unit when working on unit or draining tray
- Handle panels carefully, they have sharp points and edges
- Gloves should be worn when adding pH up or down
- Use a large spoon or srring paddle to mix nutrients
- Place PyramidGarden on level area and away from high winds
Please ensure to set up your Pyramid Garden on a at level area.

Safety & Setup Instrucons
When opening the box of your Pyramid Garden, it should include:
- Four pyramid panels
- Grow pucks
- Net pots
- Irrigaon with misters
- Extrusion connectors
- Control box / cycle mer
- Starter seeds & Nutrients
- pH test kit
- Jet & Oxygen pump (built in)
- Tray / reservoir
- Screw top
- Air stone

Safety & Setup Instrucons
** Assembly **
To build the pyramid:
On a so surface, prepare the
four panels and extrusion strips.
Ensure the bevels are facing up
and the at corner is noted for
the top of the pyramid.
The curved part of the extrusion
strips will be the top.
Align the rst panel and strip. Insert
the strip starng from the boom and
working to the top. Ensure the strips
are snug on the panels.
Boom strip should be aligned with
the top of the bevel. See photo on
right.
There should be a gap at the top
of the panel to allow for the
screw top. (Installed last)

Safety & Setup Instrucons
** Assembly **
Align the second panel with the
boom of the strip and gently
squeeze rmly to connect the panel
towards the top.
Tip: Use the holes as grab holes to
bring panels and strips together.
Connue adding panels and
strips unl the last strip has been
installed.
Without the last strip and rst
panel being connected, pull the
panels upward to create the pyr-
amid form.
Between the gap, insert the top
screw and slide to the top.
This component will bring the
panels together and strengthen
the pyramid.

Safety & Setup Instrucons
** Assembly **
Align the screw as shown.
Make the nal connecon of the
last panel and strip to complete
the pyramid form.
Ensure the top screw is aligned as shown
in photo. Tighten the screw clockwise un-
l you feel the whole pyramid ghten up.
Tip: Do not over ghten as screw may
break.
Pyramid grow are should be complete
as show in photo.
Insert irrigaon pipe by screwing into
connector. Ensure misters are
poinng towards corners of trays as
best as possible.
Insert oxygen stone tube into oxygen
pump port.

Safety & Setup Instrucons
** Assembly **
Irrigaon and oxygen
irrigaon shown in photo
with lter as complete.
Take wrapping o cycle
mer.
Place the pyramid into the
tray area ensuring that all
the panel t snugly inside
the lip of the tray.
Now you are ready to grow!