Energenie DSP-DVI-21 User manual

DSP-DVI-21, DSP-DVI-41
DVI interface splitter
USER MANUAL

2
DVI interface splitter
USER MANUAL
Disclaimer
We spared no efforts to make sure that the information in this manual is
correct and complete. However no liability is accepted for any errors or
omissions. Gembird Electronics reserves the right to change the
specifications of the hardware and software described in this manual without
prior notice.
No part of this manual may be reproduced, transmitted or translated in
any language in any form, by any means, without the prior written permission
of Gembird Electronics Ltd.
Gembird Electronics makes no warranties for damages resulting from
corrupted or lost data due to a mistaken operation or malfunction of the
product, the software, personal computers or peripheral devices.
Energenie® is a registered trademark of Gembird Europe bv.
Other names or products not mentioned above may be registered
trademarks or trademarks of their respective owners.
Copyright © 2009 Gembird Electronics Ltd. All rights reserved

3
DVI interface splitter
USER MANUAL
Features
Sends the digital DVI signal to 2 (4)* monitors
The digital 1.65 GHz bandwidth amplifier not only increases the
transmission distance with about 10 meters but also improves quality
of the signal
Specifications
Ports: one input receptacle, 2 (4)* output DVI-I output receptacles,
25+5 pin (only digital signals used)
Interface standard: DVI v.1.0, DDC2B protocol
Video formats: single link up to 1920x1200 pixels at 60 Hz of the
vertical refresh rate
Video amplifier bandwidth: up to 1.65 GHz
Power adapter: 100-240 VAC to 9 (12)* VDC, 2 A
Dimensions: 150 x 74 x 31 mm (240 x 89 x 31 mm)*
Note: * –for DSP-DVI-41 model

4
DVI interface splitter
USER MANUAL
Dear Customer
Thank you for purchasing our DSP-DVI-21 or DSP-DVI-41 DVI interface
splitter! For optimum performance and safety, please read these instructions
carefully before connecting, operating or adjusting this product. Please keep
this manual for future reference.
Installation
1. Please make sure that all the devices to be connected to the splitter
are powered off before the installation.
2. Connect the DVI input source with the DVI splitter (cable is not
enclosed).
3. Connect the DVI output devices with the DVI splitter (cables are not
enclosed).
4. Connect power supply unit with the DVI splitter and then plug it into
the wall outlet.
5. Power your DVI source and output devices on.

5
DVI interface splitter
USER MANUAL
Product overview
DSP-DVI-21
Front side:
Back side:
Power LED
Power socket
DVI input port
2 DVI output ports

6
DVI interface splitter
USER MANUAL
DSP-DVI-41
Front side:
Back side:
DVI input port
Power socket
4 DVI output ports
Power LED

7
DVI interface splitter
USER MANUAL
Precautions:
AC 220V-240V only
Clean the splitter with a dry cloth only
Do not expose to lightning.
Do not put anything inside the splitter.
If the product is broken turn the power off
Avoid water and humidity

8
DVI interface splitter
USER MANUAL
Do not touch the plug with wet hands
Do not break the power cable or plug
Do not open or disassemble the
product yourself
Do not expose to strong sunlight or
any other heat source