EnerSys OutBack POWER ALPHA OUTBACK ENERGY... User manual
Outnck
PWER'"
an EnerSys company
ALPHA
OUTBACK
ENERGV
Wiring requirements are
site-specific and will vary by installation.
ese instructions are r use by qualied peonnel who meet all local and
govemental code requiremen r licensing and training r the installation of
electrical power tems with AC and DC voltage up to 600 vol.
GS Load Center Installation Manual
Grounding lnstructions
@
900-0146-01-00 REV A
Tools Required
Components
900-0146-01-00 REVA
Table 1 Parts List
ltem Quantity
4
►
►
►
►
►
►
► 4
►
►
►
►
Figure 2 Bus Bar Positions
900-0146-01 ·00 REV A
IMPORTANT:
3
1
4
Open to 90 degrees
Remove
(x4)
Main
Bracket
lnterior
Cover
Remove (x3)
Remove
(x3)
Figure 3 Removing the Covers and Main Bracket
900-0146-01-00 REV A
H
7"
Tabs"�
—
i
pHS 8„0: j
�- ·
GROUND
IN
✓
Figure 5 Basic AC Wiring
-
8 900-0146·01-00 REVA
About OutBack Power Technologies
Disclaimer
Notice of Copyright
Trademarks
Date and Revision
Part Number
Worldwide Corporate Offices
Alpha and Outback Energy GmbH reserves the right to make changes to the products and information contained in this document without notice. Copyright © 2020 Alpha and Outback Energy GmbH. All
Rights reserved.
Headquarter Germany
Hansastrasse 8
D-91126 Schwabach
Tel: +49 9122 79889 0
Fax: +49 9122 79889 21
Mail: [email protected]
France and Benelux
fbnl@alpha-outback-energy.com
Spain
For more information please visit www.alpha-outback-energy.com
Russia
russia@alpha-outback-energy.com
Africa
Eastern Europe
Middle East
Table of contents
Other EnerSys Industrial Equipment manuals
