ENS SK1I01M User manual

Card Enrollment Station
User Manual

Card Enrollment Station·User Manual
iii
Regulatory Information
FCC Information
FCC compliance: This equipment has been tested and found to
comply with the limits for a digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
EU Conformity Statement
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized European
standards listed under the Low Voltage Directive 2006/95/EC, the
EMC Directive 2004/108/EC, the RoHS Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with
this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more information
see: www.recyclethis.info.

Card Enrollment Station·User Manual
iv
2006/66/EC (battery directive): This product contains
a battery that cannot be disposed of as unsorted
municipal waste in the European Union. See the
product documentation for specific battery
information. The battery is marked with this symbol,
which may include lettering to indicate cadmium (Cd), lead (Pb),
or mercury (Hg). For proper recycling, return the battery to your
supplier or to a designated collection point. For more information
see: www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards
requirements.
Safety Instruction
These instructions are intended to ensure that user can use the
product correctly to avoid danger or property loss.
The precaution measure is divided into Warnings and Cautions:
Warnings: Neglecting any of the warnings may cause serious
injury or death.
Cautions: Neglecting any of the cautions may cause injury or
equipment damage.
Warnings Follow
these safeguards to
prevent serious injury
or death.
Cautions Follow these
precautions to prevent
potential injury or
material damage.

Card Enrollment Station·User Manual
v
Warnings
All the electronic operation should be strictly compliance with
the electrical safety regulations, fire prevention regulations and
other related regulations in your local region.
Please use the power adapter, which is provided by normal
company. The power consumption cannot be less than the
required value.
Do not connect several devices to one power adapter as
adapter overload may cause over-heat or fire hazard.
Please make sure that the power has been disconnected before
you wire, install or dismantle the device.
When the product is installed on wall or ceiling, the device shall
be firmly fixed.
If smoke, odors or noise rise from the device, turn off the
power at once and unplug the power cable, and then please
contact the service center.
If the product does not work properly, please contact your
dealer or the nearest service center. Never attempt to
disassemble the device yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.)
Cautions
Do not drop the device or subject it to physical shock, and do
not expose it to high electromagnetism radiation. Avoid the
equipment installation on vibrations surface or places subject to
shock (ignorance can cause equipment damage).
Do not place the device in extremely hot (refer to the
specification of the device for the detailed operating
temperature), cold, dusty or damp locations, and do not expose
it to high electromagnetic radiation.
The device cover for indoor use shall be kept from rain and
moisture.

Card Enrollment Station·User Manual
vi
Exposing the equipment to direct sun light, low ventilation or
heat source such as heater or radiator is forbidden (ignorance
can cause fire danger).
Do not aim the device at the sun or extra bright places. A
blooming or smear may occur otherwise (which is not a
malfunction however), and affecting the endurance of sensor at
the same time.
Please use the provided glove when open up the device cover,
avoid direct contact with the device cover, because the acidic
sweat of the fingers may erode the surface coating of the device
cover.
Please use a soft and dry cloth when clean inside and outside
surfaces of the device cover, do not use alkaline detergents.
Please keep all wrappers after unpack them for future use. In
case of any failure occurred, you need to return the device to
the factory with the original wrapper. Transportation without
the original wrapper may result in damage on the device and
lead to additional costs.
Improper use or replacement of the battery may result in
hazard of explosion. Replace with the same or equivalent type
only. Dispose of used batteries according to the instructions
provided by the battery manufacturer.

Card Enrollment Station·User Manual
vii
Table of Contents
1 Overview...................................................................................................... 1
1.1 Introduction ........................................................................... 1
1.2 Main Features ........................................................................ 2
1.3 Appearance ............................................................................ 2
2 Connection Description ................................................................................3
2.1 USB Interface Connection ...................................................... 3
2.2 Communication...................................................................... 3

Card Enrollment Station·User Manual
1
1Overview
1.1 Introduction
D8E Series Card Enrollment StationFigure 1-1
The picture is only for reference. Please refer to the actual
products.
D8E is a non-touch IC card enrollment station, used as a
necessary non-touch card test machine by card issuers,
chip suppliers, and testing organizations. The size of its
SAM cassette equals to that of two SIM cards. The card
enrollment station can connect to PC or other devices via
USB interface. No-driver USB is applied to facilitate the
installation and operation of the card enrollment station.
It is a front-end device which is necessary for developing IC
card-related products or integrating system. With a wide
variety of well-defined APIs (Application Programming
Interface), the card enrollment station can widely applied
in various industries and situations, such as business,
telecommunication, post, insurance, medical treatment,
bank, gasoline station, parking lot, and so on.

Card Enrollment Station·User Manual
2
1.2 Main Features
Plug-and-play USB with no-driver technology
2 SAM cassettes (standard configuration)
Supports on-line upgrade
Supports various card types (Mifare card, CPU, PSAM, and EM
card)
Well-defined API
Adopts high-level encryption algorithm to ensure the security
for data communication
Provides general interface library supporting various
operation systems and language development platform
Supports USB upgrade
Auto-adapt with PSAM card of multiple baud rate
1.3 Appearance
Appearance of Card Enrollment StationFigure 1-2
The picture is only for reference. Please refer to the actual
products.

Card Enrollment Station·User Manual
3
2Connection Description
2.1 USB Interface Connection
Plug the wiring of USB into the USB interface of PC directly.
USB Interface ConnectionFigure 2-1
The picture is only for reference. Please refer to the actual
products.
2.2 Communication
When the card enrollment station is identified by the PC, its
indicator will turn blue, and item “HID-compliant device”or “USB
Input Device”will display in the computer control panel of PC.

Card Enrollment Station·User Manual
4
Computer Control PanelFigure 2-2