Enso ePurifier User manual
1. Product
a. Negative Ion Emitter
b. On/O Button and Indicator Light
c. USB Port
d. Conductive Lanyard
e. USB Charging Cable
2.Safety Instructions
READ ALL INSTRUCTIONS BEFORE USING
• Patients with respiratory diseases or people who use cardiac
pacemakers should consult doctor before using ePurifier.
• Refrain from touching (directly or indirectly) the negative ion
emitter when the ePurifier is in operation. This may adversely
affect the performance and life of ePurifer, as well as giving
you a slight electric shock.
• Do not allow children to play with the ePurifier.
• Please do not put the negative ion emitter brush too close to
your face.
• Do not immerse the ePurifier in liquid or allow liquid to enter it.
• Do not disassemble this product as this may cause a fire or
product failure.
• Keep the ePurifier away from direct sunlight or any other heat
sources, such as gas-powered stoves and ovens. Do not use
this product in areas where there are flammable or combustible
units, or wherever flammable vapors may be present.
• Do not use the ePurifier under a blanket or pillow.
• Do not place or store the ePurifier where it can fall or be
pulled into a tub or sink.
3.Operating Instructions
3.1 How to charge
•Connect the USB charging cable to the ePurifier USB port.
•Connect the other side of USB charging cable to a USB power
source. A red light indicates on the ePurifier's button that the
device is charging. The red light turns o when fully charged.
•Please unplug the USB charging cable when the ePurifier is
fully charged.
3.2 How to use
•Wear the lanyard attached to the ePurifier. The lanyard is
adjustable so that you can adjust the distance between your
face and the ePurifier (the recommended distance is about
20cm). For best ion generation performance, ensure that the
lanyard touches your skin during operation.
•Power on: press the on/o button on the ePurifier and hold for
~2 seconds until a blue light starts blinking.
•Aura mode: press the on/o button once; the blue light should
start to blink more rapidly. The negative ion emitter will
operate at maximum power for ~5 minutes and return to the
normal operating mode automatically.
•Power o: press the on/o button on the ePurifier and hold
for ~2 seconds until the blue light stops blinking.
•Low battery: a red light blinks when battery capacity goes
below 30%. Please recharge the ePurifier.
3.3 How to clean
•Turn ePurifier o and unplug the charging cable.
•Wipe the exterior and the conductive lanyard with a soft,
damp cloth. Then dry it with a soft dry cloth. DO NOT use
corrosive detergent or chemicals for cleaning. ALWAYS allow
the exterior to dry completely before turning your ePurifier on.
4. Product Specification
• Dimension: Ø 46mm x 15mm
• Net Weight: 28g
• Power Supply: Li-polymer battery
• Input: DC5V/0.5A
• Ion Density: 20 million ions/cm3
• Charging Time: ~2-3 hours
• Running Time: up to 30 hours
• Country of Origin: China
Specifications are subject to change without prior notice. If there
is any inconsistency or ambiguity between the English and the
Chinese version, the Chinese version shall prevail.
一年免費保修
1 Year Limited Warranty
Enso為ePurifier提供自購買日起一年的免費保修服務。在保修期
內若產品主機本身出現非人為因素造成的不良、瑕疵或損壞，可予
以保修。在享有保修服務時，必須保持發票正本或銷售憑證齊全。
如您覺得您的ePurifier已損壞，請電郵至[email protected]或
WhatsApp訊息至 6216-5119 與我們的客戶服務部聯絡。
Enso warrants that ePurifier shall be free from defects in
materials or workmanship under normal use and service for a
period of one year from the date of original purchase. Oicial
receipt will be required for any warranty request arised.
In the event of a malfunction or failure of your ePurifier, please
email at [email protected], or contact our Customer Service
Team at 6216-5119 through WhatsApp text message.
欲了解更多信息，請到：
For more information, please visit:
www.enso.com.hk
2020©新匯電業國際有限公司版權所有。
2020©Simway Electrical Co. International Limited. All rights reserved.
a
d
ce
b
1. 產品概述
a. 負離子碳刷頭
b. 電源鍵及指示燈
c. USB充電埠
2. 安全說明
使用前請閱讀使用說明書
˙ 呼吸病患者或正使用心臟起搏器者，請先諮詢醫生並得到許可後，
再行使用。
˙ 在電源閞啟時，請勿觸碰負離子碳刷頭，或放入任何異物，有可能影
響負離子釋放及產品壽命，同時會產生輕微觸電感覺。
˙ 請勿將ePurifier當作兒童玩具使用。
˙ 請勿將負離子碳刷頭放近臉部任何器官。
˙ 請勿浸入液體或讓任何液體進入產品內部。
˙ 請勿自行拆卸，以免引起火災或其他不可預期的損害。
˙ 儲存時應避免陽光直曬，遠離熱源，如氣體煮食爐與焗爐，並不要在
可能發生爆炸或充滿水氣的空間內使用。
˙ 請勿在毯子或枕頭下使用。
˙ 請避免摔落地面或掉入水中。
3. 操作說明
3.1 如何充電
˙ 將USB充電線插入ePurifier USB充電埠。
˙ 再將USB充電線另一端插入充電變壓器或是電腦的USB插槽，便開
始充電。充電時紅色的LED指示燈亮起，充滿電時紅色的LED指示燈
會熄滅。
˙ 完成充電後，請將USB充電線取出後再使用。
3.2 開始使用
˙ 將專用導電掛繩連ePurifier掛在頸上，調整掛繩使負離子碳刷頭朝
向面部方向(建議距離約20cm)，在使用過程中確保導電掛繩接觸皮
膚，以達到最佳效果。
˙ 開機 ： 長按電源鍵約2秒，LED閃亮藍色。
˙ Aura模式 ： 再次短按一下電源鍵，LED迅速地閃亮藍色。負離子發射
器將以最大功率運行約5分鐘後，自動回復正常模式。
˙ 關機 ： 長按電源鍵約2秒藍色燈熄滅。
˙ 當電量不足30%時，LED閃亮紅色，請進行充電。
3.3 如何清潔
˙ 在清潔前，請確保ePurifier處於關機狀態。
˙ 請定期用濕布擦拭ePurifier的外殼及導電掛繩，然後用乾布抹乾，
請勿用帶腐蝕性的清潔劑擦洗ePurifier的外殼。
˙ 無論任何時刻，在使用ePurifier前，都需確保ePurifier是乾燥狀態。
4. 產品規格
˙ 尺 寸 ： Ø 46mm x 15mm
˙ 重 量 ： 28g
˙ 電源 ： 鋰聚合物電池
˙ 輸 入 ： DC5V/0.5A
產品規格及設計如有變更，恕不另行通知。中英文版本如有出入，一概
以中文版為準。 ePurifier
使用說明書
˙ 負離子濃度: 2000萬離子/cm3
˙ 充電時間 ： 約2-3小時
˙ 使用時間 ： 最長可達30小時
˙ 產地 ： 中國
ePurifier
User Guide
enso.com.hk
d. 導電掛繩
e. USB充電線
a
d
ce
b
