
1
CAUTION
Safety Instructions & Symbols:
Source water requirements - Please pay attention to the source water
requirements outlined below prior to installing and operating your water
ionizer.
• The source water entering the water ionizer must meet applicable
local standards that make it suitable for drinking. Despite the unit’s
built-in water filter, it should NOT be attached to a water source not
meant for drinking. The purpose of the carbon filters is to remove
residual chlorine, other chemicals, and odors from water that is
already suitable for human consumption. The filter is NOT intended as
the sole purification source for the water ionizer - use in this manner
will void the warranty, reduce the unit’s performance, shorten it’s
operational life, and could jeopardize the health and life of anyone
drinking water that could potentially be harmful.
• The water flow entering the water ionizer from the source water
connection must be 0.8 liters per minute or faster for the water ionizer
to operate properly. If the water flow is too slow, the water ionizer may
not be able to induce water flow and therefore cannot start normally.
If your municipal or other water source flows slower than 0.8 liters per
minute, you may need to install a booster pump.
• The pressure of source water that goes into the unit must be under
43.5 pounds per square inch (psi)/.03 megapascals (MPa) for your
water ionizer to operate properly and to avoid damaging the unit. If
you water pressure is higher than this, you should install a water
pressure reducer to lower the source water pressure before it’s fed
into your water ionizer.
Most City Water In The USA Works Great
WARNING
WARNING Avoid the specified action as it may destroy the unit,
cause serious injury or even death.
Avoid the specified action as it may destroy the unit or
cause serious injury.
The specified action is very important and must be
completed for the unit to function properly.
Do NOT perform the specified action.
DO NOT
IMPORTANT
SAFETY INSTRUCTIONS & SYMBOLS