Enterasys VH-8G-L3 User manual

Vertical Horizon
VH-8G-L3
Gigabit Ethernet
Switch
USER GUIDE
9033705-01

Notice
9033705-019033705-01
ELECTRICAL HAZARD: Only qualified personnel should
perform installation procedures.
NOTICE
Enterasys Networks reserves the right to make changes in specifications and other
information contained in this document and its web site without prior notice. The reader
should in all cases consult Enterasys Networks to determine whether any such changes
have been made.
The hardware, firmware, or software described in this document is subject to change
without notice.
IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY
INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES
WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING
OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE
INFORMATION CONTAINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS
BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE
POSSIBILITY OF SUCH DAMAGES.
Enterasys Networks, Inc.
500 Spaulding Turnpike
Portsmouth, NH 03801
2002 Enterasys Networks, Inc.
All Rights Reserved
Printed in Taiwan, R.O.C.
Order Number: 9033705-01 March 2002
LANVIEW is a registered trademark of Enterasys Networks. ENTERASYS
NETWORKS, NETSIGHT, MATRIX, WEBVIEW, and any logos associated therewith,
are trademarks of Enterasys Networks.
SPECTRUM is a registered trademark of Aprisma Management Technologies, Inc.
All other product names mentioned in this manual may be trademarks or registered
trademarks of their respective companies.

Notice
9033705-01
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTE:This equipment has been tested and found to comply with the limits for a class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment uses, generates, and can radiate radio
frequency energy and if not installed in accordance with the operator’s manual, may
cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause interference in which case the user will be required to
correct the interference at his own expense.
WARNING:Changes or modifications made to this device which are not expressly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
INDUSTRY CANADA NOTICE
This digital apparatus does not exceed the class A limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la class A prescrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministère des Communications du Canada.
VCCI NOTICE
This is a class A product based on the standard of the Voluntary Control Council for
Interference by Information Technology Equipment (VCCI). If this equipment is used in
a domestic environment, radio disturbance may arise. When such trouble occurs, the user
may be required to take corrective actions.

Notice
9033705-019033705-01
CLASS A ITE NOTICE
WARNING:This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate measures.

Notice
9033705-01
ENTERASYS NETWORKS, INC.
PROGRAM LICENSE AGREEMENT
BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT,
CAREFULLY READ THIS LICENSE AGREEMENT.
This document is an agreement (“Agreement”) between You, the end user, and Enterasys
Networks, Inc. (“Enterasys”) that sets forth your rights and obligations with respect to the
Enterasys software program (“Program”) in the package. The Program may be contained
in firmware, chips or other media. UTILIZING THE ENCLOSED PRODUCT, YOU
ARE AGREEING TO BECOME BOUND BY THE TERMS OF THIS AGREEMENT,
WHICH INCLUDES THE LICENSE AND THE LIMITATION OF WARRANTY AND
DISCLAIMER OF LIABILITY. IF YOU DO NOT AGREE TO THE TERMS OF THIS
AGREEMENT, RETURN THE UNOPENED PRODUCT TO ENTERASYS OR YOUR
DEALER, IF ANY, WITHIN TEN (10) DAYS FOLLOWING THE DATE OF
RECEIPT FOR A FULL REFUND.
IF YOU HAVE ANY QUESTIONS ABOUT THIS AGREEMENT, CONTACT
ENTERASYS NETWORKS
[phone]. Attn: Legal Department.
1. LICENSE.You have the right to use only the one (1) copy of the Program provided
in this package subject to the terms and conditions of this License Agreement.
You may not copy, reproduce or transmit any part of the Program except as
permitted by the Copyright Act of the United States or as authorized in writing by
Enterasys.
2. OTHER RESTRICTIONS.You may not reverse engineer, decompile, or
disassemble the Program.
3. APPLICABLE LAW.This License Agreement shall be interpreted and governed
under the laws and in the state and federal courts of New Hampshire. You accept the
personal jurisdiction and venue of the New Hampshire courts.
4. EXPORT REQUIREMENTS.You understand that Enterasys and its Affiliates are
subject to regulation by agencies of the U.S. Government, including the U.S. Department
of Commerce, which prohibit export or diversion of certain technical products to certain
countries, unless a license to export the product is obtained from the U.S. Government or
an exception from obtaining such license may be relied upon by the exporting party.
If the Program is exported from the United States pursuant to the License Exception
CIV under the U.S. Export Administration Regulations, You agree that You are a civil
end user of the Program and agree that You will use the Program for civil end uses only
and not for military purposes.

Notice
9033705-01
If the Program is exported from the United States pursuant to the License Exception TSR
under the U.S. Export Administration Regulations, in addition to the restriction on
transfer set forth in Sections 1 or 2 of this Agreement, You agree not to (i) reexport or
release the Program, the source code for the Program or technology to a national of a
country in Country Groups D:1 or E:2 (Albania, Armenia, Azerbaijan, Belarus, Bulgaria,
Cambodia, Cuba, Estonia, Georgia, Iraq, Kazakhstan, Kyrgyzstan, Laos, Latvia, Libya,
Lithuania, Moldova, North Korea, the People’s Republic of China, Romania, Russia,
Rwanda, Tajikistan, Turkmenistan, Ukraine, Uzbekistan, Vietnam, or such other
countries as may be designated by the United States Government), (ii) export to Country
Groups D:1 or E:2 (as defined herein) the direct product of the Program or the
technology, if such foreign produced direct product is subject to national security controls
as identified on the U.S. Commerce Control List, or (iii) if the direct product of the
technology is a complete plant or any major component of a plant, export to Country
Groups D:1 or E:2 the direct product of the plant or a major component thereof, if such
foreign produced direct product is subject to national security controls as identified on the
U.S. Commerce Control List or is subject to State Department controls under the U.S.
Munitions List.
5. UNITED STATES GOVERNMENT RESTRICTED RIGHTS.The enclosed
Product (i) was developed solely at private expense; (ii) contains “restricted computer
software” submitted with restricted rights in accordance with section 52.227-19 (a)
through (d) of the Commercial Computer Software-Restricted Rights Clause and its
successors, and (iii) in all respects is proprietary data belonging to Enterasys and/or its
suppliers. For Department of Defense units, the Product is considered commercial
computer software in accordance with DFARS section 227.7202-3 and its successors, and
use, duplication, or disclosure by the Government is subject to restrictions set forth
herein.
6. EXCLUSION OF WARRANTY.Except as may be specifically provided by
Enterasys in writing, Enterasys makes no warranty, expressed or implied, concerning the
Program (including its documentation and media).
ENTERASYS DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE
SUPPLIED TO YOU BY ENTERASYS IN WRITING, EITHER EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH
RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS,
AND ANY ACCOMPANYING HARDWARE.
7. NO LIABILITY FOR CONSEQUENTIAL DAMAGES.IN NO EVENT SHALL
ENTERASYS OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES
WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS
OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS
INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE
DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO
USE THIS ENTERASYS PRODUCT, EVEN IF ENTERASYS HAS BEEN ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT

Notice
9033705-01
ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR
CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR IN THE DURATION OR
LIMITATION OF IMPLIED WARRANTIES IN SOME INSTANCES, THE ABOVE
LIMITATION AND EXCLUSIONS MAY NOT APPLY TO YOU.

Notice
9033705-01
DECLARATION OF CONFORMITY
Application of Council Directive(s): 89/336/EEC
73/23/EEC
Manufacturer’s Name: Enterasys Networks,
Inc.
Manufacturer’s Address: 500 Spaulding Turnpike
PO Box 3060
Portsmouth, NH 03801
European Representative Address: Enterasys Networks Ltd.
Nexus House, Newbury
Business Park
London Road, Newbury
Berkshire RG14
2PZ, England
Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC
EC Directive 73/23/EEC
EN 55022
EN 55024
EN 60950
EN 60825
Equipment Type/Environment: Networking
Equipment, for use
in a Commercial
or Light Industrial
Environment.
Enterasys Networks, Inc. declares that the equipment packaged with this notice
conforms to the above directives.