5
3. Place food into the chopper bowl.
Note: Remove the bone of the meat, cut small piece, then place the meat
into bowl, the max quantity of meat can’t exceed 200g in every blending.
4. Attach the lid onto the chopper bowl, make sure the tuber on the inside wall
of bowl aligns with the groove of lid, then put down the lid and turn it in
clockwise direction until it locks into position. (See Fig.2) To detach the lid,
turn in adverse direction.
5. Insert the motor unit into the hole of the chopper lid, and turn in clockwise
direction to lock. (See Fig.3)
6. Plug the appliance to power outlet. Then press and hold the low speed
button to start operating. At the same time you can select desired speed
setting by dialing the speed control dial, the speed will be higher gradually
when you dial the speed control dial from left to right.
7. You can also start operating by pressing and hold the high speed button
(turbo button), the appliance will operate at the highest speed all the time.
The speed will not change even if you dial the speed control dial.
8. To stop the appliance by releasin g the low speed button or high speed
button of the motor unit.
9. After finishing chopping, unplug the power outlet firstly, then remove the
motor unit from the chopper lid by turning it in anti-clockwise.
10. Open the chopper lid by turning it in anti-clockwise and remove the
chopped food.
CAUTION:
- To reduce the risk of injury, never pl ace cutting blade on base without first
putting bowl properly in place.
- Be sure chopper lid is securely locked in place before operating appliance.
- After chopping, for safety, you shall disassemble the motor unit from the
chopper lid firstly, then remove the chopper lid. Never remove the chopper lid
with the motor unit in place.
