Epson Stylus CX3900 Series Instruction and safety manual

User’s Guide
— for use without a computer —
Loading Paper
Placing an Original
Copying
Replacing Ink Cartridges
Open Close
Photo Copy without Borders
Reduced Scale Copy
Document Copy Draft Document Copy
Hold ybutton and press xbutton
Photo Copy with Borders
or
Enlarged Scale Copy
or
Cancel Copy
or
Press
Open Install Click
Close (Click) Close Press
Open
The _mark
indicates a
low or
expended
ink cartridge.
Remove
Repeat this step to check other cartridges.
Checking the Ink Cartridge Status /
Removing and Installing Ink Cartridges
Epson Ink Cartridges
Color Part Number
Black T0731
Cyan T0732
Magenta T0733
Yellow T0734
Press
Flashing On
Wait about 1 min
Shake Unpack
Only remove
the yellow tape
Note:
Do not open the ink cartridge package until you are ready to install it in the printer.
The cartridge is vacuum packed to maintain its reliability.
Copyright © 2006 Seiko Epson Corporation. All rights reserved.
Printed in XXXXXX XX.XX-XX XXX
= On
Loading Capacity
Available Paper Paper Size Sheets
Plain Paper
A4 100
Epson Premium Ink Jet
Plain Paper
Epson Bright White Ink
Jet Paper A4 80
Epson Premium Glossy
Photo Paper
10 ×15 cm
(4 ×6 in.) 20
Epson Premium
Semigloss Photo Paper
Epson Glossy Photo
Paper
Epson Ultra Glossy
Photo Paper

Troubleshooting
Error Indicators
Copy Problems
Lights Cause Solution
&See Loading Paper on the front page.
Other lights off
Sleep mode Press the button to wake the product.
or
&See Replacing Ink Cartridges on
the front page.
If the light is still on or flashing after you replace the cartridge, try the
procedure below.
All lights
flashing Contact your dealer.
Other lights
flashing
Waste ink pad in the
printer is saturated. Contact your dealer to replace it.
Lights Cause Solution
Turn off
or
Turn off
If the paper is not ejected, try the procedures below.
2.5 mm
soft, dry cloth
Close the cover
tightly.
1. Nozzle Check
Try 1. Nozzle Check
Press for 3 sec Wait
Flashing On
2. Print Head Cleaning
Turn off
Banding
Faint
Hold Bbutton and press
Pbutton for 3 sec
Colors missing
Good printout
Problem with printout
&Run a nozzle check
= Flashing, / = On