Epson brightlink User manual

Page 1 of 4
© D. Rich, 2012
Epson Brightlink Interactive
Projector – Volume Adjustments
If the volume on your ceiling speakers for your Epson wall mounted projector are not loud
enough, try the following:
STEP #1
Make sure the audio cable is connected securely to the audio jack on the wall plate.
NOTE: There are two different kinds of audio cables in use in the district. One is a part of the
VGA cable, and the other is a separate audio cable.
VGA and Audio
NOTE: VGA must remain plugged in to its
current location.
Audio Only
STEP #2
Plug in the other end of the audio cable to the front
audio jack on your computer.

Page 2 of 4
© D. Rich, 2012
If you have a speaker bar on your monitor, you may connect the audio cable to the speaker bar
instead of the front audio jack. Speaker bar must be powered on, and volume must be turned up.
Connect audio cable to audio port on left side of speaker bar.

Page 3 of 4
© D. Rich, 2012
STEP #3
If you have external speakers connected to the back your computer, unplug them.
STEP #4
Turn the projector on, and project your
computer desktop image.
Use the remote to make sure that the
volume is turned up on the projector.

Page 4 of 4
© D. Rich, 2012
STEP #5
Check to make sure that the volume on your computer is turned up.
Double click on the speaker icon near the clock.
Windows XP View Windows 7 View
Make sure that all volume sliders are turned up to maximum, and that the volume is not muted.
Windows XP View Windows 7 View
STEP #6
If you are showing a video, or listening to audio, make sure that the audio player volume is
turned up.