Epson PowerLite 4100 System manual

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 4100 / 4200W / 4300
1
Cleaning the Air Filter
Your projector includes an air lter to ensure the best performance. If
dust collects on the air lter (on the side of the projector), you see a
message on the screen telling you to clean the lter, or the
Temp
light ashes green, clean the lter. Dust clogs
prevent proper ventilation and can cause overheating, which can
damage the projector.
note
To order replacement air
lters, request part number
V13H134A17.
Follow these steps:
1. Press thePpower button on the back of the projector to turn it
o. After the projector beeps twice, unplug the power cord.
2. Grip the air lter cover tab and remove the air lter cover as
shown.
3. Place your nger into the groove and remove the air lter as
shown.

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 4100 / 4200W / 4300
2
4. With the front of the air lter facing down, tap it four or ve
times to shake o the dust. Turn it over and tap the other side in
the same way to shake o the dust.
5. To clean any dust remaining on the air lter, use a small vacuum
cleaner designed for computer and other oce equipment to
clean the front. If you don’t have one, gently clean the vent with a
soft brush (such as an artist’s paintbrush).
6. Insert the air lter back into the holes in the cover, then press it
rmly into place.
7. Slide the air lter cover in until it clicks into place.

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 4100 / 4200W / 4300
3
8. If the dirt is dicult to remove,the lter is broken or discolored,
or you continue to see air lter related messages even after
cleaning, replace the lter as described in the next section.
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766) to obtain a new lter.
Replacing the Air Filter
Follow these steps to replace the air lter:
1. Press the Ppower button on the back of the projector to turn it
o. After the projector beeps twice, unplug the power cord.
2. Grip the air lter cover tab and remove the air lter cover as
shown.
3. Place your nger into the groove and remove the air lter as
shown.
4. Insert the new air lter into the holes in the cover, then press it
rmly into place.
note
The air lter contains
Polypropylene. Dispose of
used air lters properly in
accordance with your local
regulations.

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 4100 / 4200W / 4300
4
5. Slide the air lter cover in until it clicks into place.