Epson PowerLite 1750 System manual

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 1750 / 1760W / 1770W / 1775W
1
Replacing the Lamp
Before you replace the lamp, let the projector cool down for at least one hour so the lamp will not be hot.
Warning: Let the lamp fully cool before replacing it to avoid injury.
You can replace the lamp while the projector is mounted to the ceiling, if necessary.
1. Turn off the projector and unplug the power cord.
2. Allow the projector lamp to cool down for at least one hour.
3. Use the screwdriver included with the replacement lamp to loosen the screw securing the lamp
cover.
Warning: If the lamp is broken, glass fragments may be loose inside the lamp chamber. Be careful
removing any broken glass to avoid injury.
4. Slide the lamp cover out and lift it off.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 1750 / 1760W / 1770W / 1775W
2
6. Lift up the lamp handle and gently pull the lamp out of the projector.
Caution: Lift the lamp handle carefully to avoid damaging the handle as you pull out the lamp.
Note: The lamp(s) in this product contain mercury. Please consult your state and local
regulations regarding disposal or recycling. Do not put in the trash.
5. Lift up the metal bar securing the lamp.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 1750 / 1760W / 1770W / 1775W
3
7. Gently insert the new lamp into the projector. If it does not fit easily, make sure it is facing the right
way. Press down on the area shown to secure the lamp in place.
Caution: Do not touch any glass on the lamp assembly to avoid premature lamp failure.
8. Press the metal bar down over the lamp until it clicks into place on both sides.
9. Replace the lamp cover and tighten the screw to secure it.
Note: Be sure the lamp cover is securely installed or the lamp will not come on.
Reset the lamp timer to zero to keep track of the new lamp’s usage.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 1750 / 1760W / 1770W / 1775W
4
Resetting the Lamp Timer
You must reset the lamp timer after replacing the projector's lamp to clear the lamp replacement
message and to keep track of lamp usage correctly.
Note: Do not reset the lamp timer if you have not replaced the lamp to avoid inaccurate lamp usage
information.
1. Turn on the projector.
2. Press the Menu button.
3. Select the Reset menu and press Enter.
4. Select Reset Lamp Hours and press Enter.
You see a prompt asking if you want to reset the lamp hours.
5. Select Yes and press Enter.