Epson Expression 11000XL - Graphic Arts User manual

Home > Using the Transparency Unit
Installing the Transparency Unit
Follow the steps below to install the Transparency Unit.
Make sure the scanner is turned off, and then unplug the power cord from the scanner.
Open the scanner’s document cover, and then remove it by lifting the cover straight up.
Align the pins of the unit with the holes of the scanner, and then lower the Transparency Unit
until it rests securely on the scanner with the pins in the holes.
Page 1 of 3Installing the Transparency Unit
4/12/2013mhtml:htt
p
://share
p
oint01/su
pp
ort/FAQ/Lists/Ea
g
leSoft FAQ Re
q
uests/Attachments/4123
/
...
18348_Epson_11000XL_Transparency_Unit_Installation_Instructions_Rev.1_4.17.2013

Remove the reflective document mat from the Transparency Unit as shown below.
Place the transparency guide on the scanner glass as shown below.
Page 2 of 3Installing the Transparency Unit
4/12/2013mhtml:htt
p
://share
p
oint01/su
pp
ort/FAQ/Lists/Ea
g
leSoft FAQ Re
q
uests/Attachments/4123
/
...

To scan slides or strips of negative or positive films, see Setting and Placing Film.
Close the Transparency Unit.
Connect the Transparency Unit’s connector to the option connector on the back of the
scanner.
Connect the power cord to the scanner and then turn on the scanner.
Important:
Do not put heavy objects on the Transparency Unit; otherwise the unit may be
damaged.
Home Contents Index Help
(NPD4827-00 EN)
Page 3 of 3Installing the Transparency Unit
4/12/2013mhtml:htt
p
://share
p
oint01/su
pp
ort/FAQ/Lists/Ea
g
leSoft FAQ Re
q
uests/Attachments/4123
/
...