Equipex Sodir TS-127 User manual

Operation Manual
For
Sodir
TS-127 and TS327
765 Westminster Street Providence, Rhode Island 02903 U.S.A.
Tel: [phone] Fax: [phone]
www.equipex.com e-mail: [e-mail]
11/27/12

IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read all the instructions before use.
2. Do not touch hot surfaces; use handles or knobs.
3. To avoid electric shock, do not immerse the power cord, or any part of the unit, in any liquid.
4. Close supervision is necessary when any appliance is used, especially around children.
5. Unplug appliance from the electrical outlet when not in use, and before cleaning. Allow appliance
to cool before installing or removing any parts or accessories, and before cleaning.
6. Do not operate any appliance with a damaged cord or plug, or if appliance should sustain
damage, or malfunction in any way. In this event, return appliance to the nearest authorized
service facility for examination, repair or adjustment.
7. The use of accessories and/or attachments not recommended by the appliance manufacturer
may cause injury or damage to the appliance, and may void your warranty.
8. Do not use outdoors.
9. Do not allow the power cord to hang over the edge of a table or counter, or to be exposed to hot
surfaces, as damage may occur.
10. Do not place appliance on or near a burner, or in a heated oven.
11. To disconnect an appliance, first turn all controls to the ‘off’ position; then unplug the power cord
from the wall outlet.
12. Do not use appliance other than for its intended use.
13. SAVE THESE INSTRUCTIONS FOR LATER USE!

INTRODUCTION
The SODIR models TS127 and TS-327 countertop snack toasters are designed to
offer speedy toasting melting and finishing. The toasters are constructed of food service
quality stainless steel for commercial applications, and are especially useful where a
small footprint is needed.The units are equipped with quartz heating elements, which
reach full temperature in seconds, a four-position mode switch and a 13-minute timer
on the TS-327, or 15-minute timer on the TS-127. Both have constant on position. A
green power indicator light turns on when the timer is turned on, and an orange element
indicator light turns on when the mode switch is moved from the off position. The TS-127
comes with one wire rack with handles, and the TS-327 comes with two, one of which,
used on the top, has a removable integrated cover panel to help hold in the heat.
Specifications:
Model Electrical Plug
Configuration
TS-127 208/240V, 1 PH, 3.0KW, 11/13A NEMA-6-20P
TS-327 208/240V, 1 PH, 4.8KW, 18/20A NEMA-L6-30P
INSTALLATION
The SODIR toaster needs to be connected to a grounded outlet of proper voltage of
208/240V. DO NOT place the unit in a damp area or near steam sources. If toaster
is installed over heating elements or burners, place it on an insulated shelf. When
positioning the toaster, make sure that the ventilation holes are not blocked,
especially at the rear. Maintain 4” clearance at each side, rear and top of the toaster.
ASSEMBLY
The SODIR toaster comes from the factory completely assembled. It is shipped
with plastic exterior protective film, which must be removed before operation. DO
NOT operate the toaster prior to removing the protective film completely.

OPERATION
Cooking
To operate the snack toaster, rotate the mode switch knob clockwise to the desired element
setting - top, bottom or all elements on. Minor (10-25 seconds) preheating is necessary.
On the TS-327 model, the center row of quartz tubes operates in all positions but the off
position. Next, turn the timer knob, which also acts as an ON/OFF switch, to the desired
time setting, or constant ‘on’ position designated by the hand graphic. Both indicator lights
(green and orange) will be lit. The orange light will stay on when the heating elements are
operating. The green light will stay on until the timer expires or is turned off.
The SODIR snack toasters can be used for a wide variety of foods. Cooking times will vary
depending on food product temperature and type, and desired results.
Cleaning
WARNING: Disconnect (unplug) electrical power supply before cleaning
Cleaning is very important in maintaining a safe and well working machine. Allow the toaster
to cool before cleaning. Remove the baking racks and clean them separately using a damp
cloth or sponge and mild liquid soap. Use a cloth dampened slightly with a soap and water
mixture to clean all exterior and interior stainless steel surfaces. Use a clean lint-free cloth to
remove the excess water or soap. Make sure no water enters the unit through ventilation
holes.
DO NOT use an abrasive sponge on exterior or interior surfaces
DO NOT wash the toaster under running water
DO NOT spray the exterior motor housing with any liquid
DO NOT allow water to drip into the housing or onto electrical components
Maintenance
You should inspect all parts on a regular basis to ensure that all is in proper working order. If a
part is damaged, have the unit repaired by an authorized service agency prior to returning the
unit to operation. If you have trouble locating a service agency in your area, please consult our
website at http://www.equipex.com/, or call us at 1-800-649-7885 and ask for customer service.

Spare Parts TS-127

Spare Parts TS-127
DWG # Part Number Qty Description
144043 1Roof
244044 1Inside roof
3D04033 6Tube quartz assembly
4F01026 2Tubes protecting grid
544048SE 1Left upright
6B07025 12 Clips
744046 2Wall
8OEM0022 1Cord with plug
9A10032 1Cord closer 16
10 44037 1Bottom enclosure
11 A13017 4Foot
12 44047SE 1Right upright
13 A17010 2Grid holder handle
14 F01062 1Grid
15 44041 1Tray
16 A02008 1Timer
17 A14078 2Knob
18 A08009 1Green pilot light
19 A08003 1Orange pilot light
20 A01017 1Mode Switch
21 A16013 1Three Position Terminal Block

Spare Parts TS-327

Spare Parts TS-327
DWG# Part Number Qty Description
144043 1Roof
244044 1Inside roof
3F01062 2Grid
444035 1Grid deflector
5D04033 9Tube quartz assembly
6F01026 4Tubes protecting grid
7B07025 18 Clips
844040SE 1Left upright
944036 2Wall
10 OEM0052 1Cord
11 A10032 1Cord closer 16
12 44037 1Bottom enclosure
13 A13017 4Foot
14 A17010 4Grid holder handle
15 44039SE 1Right upright
16 44041 1Tray
17 A02002 1Timer
18 A14078 2Knob
19 A08009 1Green pilot light
20 A08003 1Orange pilot light
21 A01017 1Mode Switch
22 A16013 2Three Position Terminal Block

LIMITED WARRANTY
Your new EQUIPEX product is warranted to the original purchaser for a period of one year from the date of purchase.
This limited warranty is against defects from original factory imperfections in material and/or workmanship
and includes labor for replacement of defective parts, provided repairs are performed by an authorized service
agency. Our obligation under this warranty is limited to repairing or replacing any part or parts thereof. The
CUSTOMER must inform the Service Agency of warranty coverage and provide a copy of the dated sales or
delivery receipt BEFORE WARRANTY REPAIRS BEGIN. Replacement parts and accessories are warranted for
ninety (90) days from the date of purchase when purchased separately and will be verified by dated sales receipt or
packing slip for that item. All parts or accessories replaced under warranty must be returned to the Service Agency.
This warranty applies only to equipment under normal use and service in the U.S.A. and Canada. It does not
apply to any item which has been repaired or altered in any way so as, in the judgment of EQUIPEX, to affect its
reliability.
THE FOLLOWING ARE NOT COVERED UNDER WARRANTY:
1. Damage caused by abuse, misuse or dropping or other similar incidental damage caused by, or as a
result of, customer failure to follow assembly, operation, cleaning, user maintenance or storage
instructions.
2. Labor to replace inoperative parts such as bulbs, plugs or racks due to normal wear and tear or abuse.
3. Materials or labor to repair scratched, stained, chipped, pitted, dented or discolored surfaces, attachments or
accessories.
4. Transportation charges to or from a service agency for repair of your machine. If you should have
questions relating to this issue, please call Equipex at 1-800-649-7885.
5. Labor charges to install or test attachments or accessories, which are replaced for any reason.
6. SHIPPING DAMAGES. Visible and hidden damages are the responsibility of the freight carrier.
The consignee must file the claim promptly against the carrier. KEEP ALL ORIGINAL
CONTAINERS AND PACKAGING MATERIAL FOR CARRIER INSPECTION.
7. Products placed or stored in the equipment are not subject to this warranty and no responsibility is
assumed thereof.
THIS WARRANTY IS GIVEN EXPRESSLY AND IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, FOR MERCHANTABILITY AND FOR FITNESS TOWARD A PARTICULAR PURPOSE AND
CONSTITUTES THE ONLY WARRANTY MADE BY EQUIPEX, LLC. IT NEITHER ASSUMES, NOR AUTHORIZES
ANY PERSON TO ASSUME FOR US, ANY OTHER LIABILI TY IN CONNECTION WITH THE SALE OF THE
SUBJECT EQUIPMENT.
For service, please call EQUIPEX at 1-800-649-7885, menu option # 3
765 Westminster Street Providence, Rhode Island 02903 U.S.A.
Tel: [phone] Fax: [phone]
www.equipex.com e-mail: [e-mail]