ESP Essentials HDMIXWF50D User manual
RX (Receiver)
TX (Transmitter)
System Set-up Example
HDMI
CCTV DVR / NVR Monitor
Quick Start Guide:
• Ensure there is a signal output from the HDMI source (connect a monitor directly)
• Connect the RX to a monitor and the TX to the HDMI source
• Connect the HDMI source to the TX, the image will display.
Please note: if the HDMI source changes resolution whilst connected to the TX, the TX will
need to be power cycled to auto adjust to the new resolution
HDMIXWF50D
WIRELESS HDMI SENDER DONGLE KIT HD 1080P 50M
HDMI
PSU
Elite Security Products
Unit 7, Target Park,
Shawbank Road, Lakeside,
Redditch B98 8YN
Telephone : 01527 51 51 50
Fax: 01527 51 51 43
Email : [email protected]
www.espuk.com
E&OE - Errors and omissions excepted.B19
Support Guide:
Transmitter and receiver are not connected
• Ensure power is applied to TX and RX
• Ensure the correct HDMI input / output have been used on the monitor and HDMI source
Connection Indicator LED is active, but no signal from the HDMI source is displayed
• Check the HDMI source output, connect directly to a monitor
• Check the HDMI source output is set to a supported resolution
Abnormal display once connected
• Reposition the system devices to improve the signal path; types of building material or interfer-
ence from other devices can severely affect the performance
Additional Notes:
As with all electronic products, ESP cannot guarantee compatibility with every available device,
and every version of a specific device.
The driver disc supplied is for PC / Laptop use.
Table of contents
