
Elite Security Products
Unit 7, Target Park,
Shawbank Road, Lakeside,
Redditch B98 8YN
Telephone : 01527 51 51 50
Fax: 01527 51 51 43
www.espuk.com
E&OE - Errors and omissions excepted.B19
Quick Start Guide:
• Ensure there is a signal output from the HDMI source (connect a monitor directly)
• Apply power to the TX and RX
• Connect the RX to a monitor and ensure there is a transmission signal between both TX
and RX
• Connect the HDMI source to the TX, the image will display.
Please note: if the HDMI source changes resolution whilst connected to the TX, the TX will
need to be power cycled to auto adjust to the new resolution
Support Guide:
Transmitter and receiver are not connected
• Ensure power is applied to TX and RX
• Ensure the correct HDMI input / output hve been used on the TX and RX
The Wi-Fi status LED is constant, but no signal from the HDMI source is displayed
• Check the HDMI source output, connect directly to a monitor
• Check the HDMI source output is set to a supported resolution
• Check HDMI cable used for the TX and RX
Abnormal display once connected
• Reposition the TX and RX to improve the signal path; types of building material or interference
from other devices can severely affect the performance
• Press the ‘Reset’ button on the TX and RX
Specificaon
HDMI Version 1.3
HDCP Version 1.2
Transfer Rate 10.2Gbps
640*480@60HZ 1280*720@60HZ 1920*1080@60HZ
HDMI Connector Type A, 19 pin, Female
Transmission Distance (Open Field)
Operang Temperature 0~50°C
Relave Humidity 0~70°C
Power Supply 5v 2A
Power Consumpon TX <7W RX <5W
Dimensions 121.4 (W) X 132 (D) X 21.5 (H) mm
HDMIXWF50<50m
HDMIXWF100<100m
Additional Notes:
As with all electronic products, ESP cannot guarantee compatibility with every available device,
and every version of a specific device.