Esselte Xyron Creativity for Kids X-Treme Sticker Maker... User manual

Creativity for Kids® has teamed up with Xyron®
to bring you the BEST sticker maker on
the planet! A favorite among crafters, this
high quality sticker machine is so fun and
super easy to use. Once you get started, you
won’t want to stop.
Your complete set includes the sticker maker,
2 rolls of sticker tape – 40 feet in all,
markers, sticker art assortment – including
velvet, glitter and foil. When you are finished,
you can show off your sticker style with
the sticker book included.
Ages 6 to 96
Important – Please read and follow all directions carefully. When loading a new sticker cartridge,
refer to the step-by-step photos and diagram listed at the end of these instructions. Your sticker
machine will not work if the cartridge is not loaded correctly. Adult assistance is recommended
for this step.
The adhesive included in your sticker set is permanent –that means once your stickers are stuck,
they are not repositionable. Check with an adult before placing stickers on any surface other than
your sticker book.
REFILLING YOUR STICKER MAKER
To remove the empty cartridge, press the
cartridge tabs in, and pull down as shown.
Discard the empty cartridge.
Troubleshooting Tips
Note – sticker paper and plastic protective sheet should come
out of the center of the roll as shown. If the tape is not in the
correct position, it will not work. Remove the center felt tab,
reinsert the tape and replace the felt tab. If the refill is not
properly inserted, you may notice extra adhesive inside the
machine. This can be removed with a glue solvent.
Note – this step should be completed by adults only.
V
i
s
i
t
o
u
r
w
e
b
s
i
t
e
a
n
d
r
a
t
e
t
h
i
s
p
r
o
d
u
c
t
T
e
l
l
u
s
w
h
a
t
y
o
u
t
h
i
n
k
!
The Complete X-Treme Sticker Maker Set #1686
© Faber-Castell USA, Inc. • Cleveland, Ohio 44125 • www.fabercastell.com
Designed in USA • Made in China • Conforms to ASTM D-4236 • Non-toxic Safe for Children
Our mission is to provide
children with experiences
that stimulate and encourage
their natural creativity.
Our open-ended products
offer fun-filled opportunities
for children to create, pretend,
explore and learn.
Our Quality Promise
Since 1976 Creativity for Kids has
been creating safe, innovative
products that meet or exceed U.S.
safety standards as determined by
independent laboratory testing.
We will also teach you how to turn your own artwork, photos,
even ribbon, into your own custom sticker creations.
Press
Ta b s
Ready to use,
just slide in
and snap
To refill the machine
To remove the cartridge
LOADING THE REFILL
Your sticker refill cartridge
should look like this.
Slide the cartridge into
the bottom as shown.
When properly inserted,
it should snap into place.
Note -The cartridge comes
ready to use, so no special
threading or feeding is needed.
Pre-loaded with 20 ft/6m of sticker tape
No
threading
needed
Additional
refill cartridges
also available.
Visit your local toy
retailer or
www.creativityforkids.com
Pull
Cartridge

DESIGN TIME
Select your favorite sticker designs
and color them in. You can also design
your own original stickers, cut out little
photos or sayings from magazines,
or use pieces of leftover ribbon
– just make sure they are small
enough to fit through the top of
the sticker maker, -no wider than 1.5”.
The length is up to you.
Keep in mind that heavy cardboard
and thicker material will not work
in your machine.
CREATE YOUR
STICKERS
With the art facing up, insert your
design into the top of the machine.
Look for the arrow to help guide
you.
Maximum Sticker Width:
1.5 inches/3.8cm
Rub the clear top of the sticker, and then
peel off this layer. Remove your sticker
from the paper and then press it into
your awesome sticker book!
As you push your art into the ma-
chine, grab the sticker paper from
the bottom and pull. As you pull,
your sticker will be “fed” into the
machine.
As soon as your sticker is all the way
through, pull up on the tape and tear
it off. For best results tear as close to
the edge of the sticker as possible, so
you don’t waste sticker tape.
Try feeding the stickers into the
machine close together, but not
touching. This will also help you
conserve your sticker tape too.
1.
2.
3.
4.
Your machine comes pre-loaded with
20 feet of sticker tape. Your set also includes
a refill with 20 more feet of tape. To purchase
additional refills, visit your local toy retailer
or www.creativityforkids.com for refill
information. You can also find Xyron sticker
refills at many hobby and craft stores.
Be sure to purchase the 1.5” refill – that is the
correct size to fit this sticker machine.
Place
Pull
Peel
Rub
Stick
Color
Te a r
Your sticker machine comes
pre-loaded, ready to use!