Essential Garden Privacy 780-06019874-4 User manual

OWNER'S MANUAL
Privacy Gazebo
Product Code: 780-06019874-4
UPC Code: 6939622430107
Date of purchase: _____ /_____ /_____

10' x 12'
gazebo

4

5
HARDWARE KIT
Item Description Qty
N Allen Key 1
O Camp Nail 12
P Screw M6x16 48
 Q ScrewM5x10 8
R Screw & Nut 8
S Hooks 104
T Wrench 1
NOTE:
Parts not shown to actual size and not to scale.
N
OPQ
ST
X1
X12
X48 X8
RX8X104
X1

6
PARTS LIST
Item Description Qty
A Column 4
B Short Track 2
B1 Short Track 2
 C LongTrack 2
 C1 LongTrack 2
D Roof Bar 4
E Roof Bar With Angled End 4
F Roof Connector 2
Item Description Qty
G Central Roof Bar 1
H Base 4
I Side Connector 4
J Central Roof Connector 1
K Canopy 1
 L Curtains 4
M Mosquito Netting 4
NOTE:
Parts not shown to actual size and not to scale.
A
D
H
LM
IJ
K
EG
X4
X4
X4
X4X4
X4
X4
X1
X1
X1
B
C
F
B1
C1
X2
X2
X2
X2
X2

Parts required for this step:
installation
7
A
H
X4
X4IX4PQ
X12 X8
Step 1
1.1 Install Side Connectors (I) on top of the Column (A)
 usingScrews(Q).Repeat4times.
1.2 Install Columns (A) onto Base (H) using Screws (P).
Repeat 4 times.
X4
X4
I
I
Q
H
H
P
AA
A

Parts required for this step:
installation
8
Step 2
2.1 Attach Short Track (B) to Short Track (B1) using Screws and Nuts (R). Repeat 2 times.
2.2 Repeatstep2.1usingLongTracks(C)andLongTrack(C1).
B
C
B1
C1
X2
X2
X2
X2
RX8
X4
R
B1or C1
Bor C
C1
B1
B
C
X2
X2

Parts required for this step:
installation
9
Step 3
3.1 Install the tracks to the columns using Screws (P).
Alternate between Track (B & B1) and Track (C & C1) until structure is completed.
C1
C1
B1
B1
B
B
C
C
NOTE:
It is imperative that the Side Connectors (I) are angled towards
the center of the sun shelter.
PX32
X4
P

Parts required for this step:
installation
10
Step 4
4.1 Anchor the sun shelter before installing the roof as follow:
Grass surface: Use included Camp Nails (O) to anchor Base (H) previously installed on your Column (A).
Camp Nails (O) cannot be used for permanent anchoring, as unit must be anchored on a hard surface for
the warranty to be valid.
Wood deck: Use wood screws (not included) to anchor Base (H) previously installed on your Column (A).
Concrete patio: Use Tapcon screws (not included) to anchor Base (H) previously installed on your Column (A).
4.2 Repeat for all remaining Columns (A).
CAUTION:
You must anchor the sun shelter before installing the roof.
IMPORTANT:
Unit must be anchored on a hard surface for the warranty to be valid.
OX12
X4
O
A
H

Parts required for this step:
installation
11
Step 5
5.1 Slide Central Roof Connector (J) onto the middle of the Central Roof Bar (G).
5.2 Insert Roof Connectors (F) on each end of the Central Roof Bar (G).
J
J
J
F
G
G
GX1
X1
F
F
X2

Parts required for this step:
installation
12
DX4
I
DD
D
D
D
D
D
X4
X2
F
Step 6
6.1 Insert one end of Roof Bar (D) into the angled bar of Roof Connector (F).
Repeat 4 times.
6.2 Install the roof structure you just built by inserting the end
of Roof Bar (D) onto Side Connector (I).

Parts required for this step:
installation
13
step 7
7.1 Insert the Roof Bar (E) to Roof Connector (F). Repeat 2 times.
7.2 Insert the Roof Bar (E) to Roof Connector (J). Repeat 2 times.
7.3 Align the pre-drilled hole in Roof Bars (E) with the pre-drilled hole in the Roof Tracks (B & C).
ensuring that the angled ends are facing downward.
Repeat 4 times.
EX4PX4
E
E
F
J
E
E
E
P
E
X4
but DO NOT TIGHTEN them as you will need to remove them to attach the canopy roof later on ( see Page 14: STEP 8.2 ).
Using the Screws (P), insert screws

Parts required for this step:
installation
14
step 8
8.1 Place Canopy (K) over the roof structure
8.3 Attach using the velcro.
KX1
X4
8.2 Align the openings in the side flaps of the Canopy (K) with
the ends of the Roof Bars (E) previously done in Step 7.3
remove the Screw (P), overlap the flap with the opening and
re-insert and tighten the screw so that the Canopy is secured
onto the crossbeam tracks.
P
E
X4

Parts required for this step:
installation
15
Step 9
9.1 InstallHooks(S)alongtheeyeletsoftheCurtains(L)andMosquitoNetting(M).
9.2 InstallCurtains(L)fromtheinsideofthesunshelter
along lower tracks of Tracks (B, B1, C & C1).
9.3 Install Mosquito Netting (M) from the inside of the sun shelter
along upper tracks of Tracks (B, B1, C & C1).
LM
X4X4
NOTE:
Each 10ft side will have a total of 24 hooks between the mosquito
netting and the curtains and the 12ft side will have a total of 28 hooks
between the mosquito netting and the curtains.

Made in / Hech en CHINA for Kmart Corporation, Hoffman Estates, IL 60179
For questions or comments about product:
Email: [email protected] or Call toll-free: 1-855-379-7070
Please refer to part numbers when reordering
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com