PARK WAREHOUSE 4 & 5 Classic and Hummingbird Gliders User manual

4' & 5' Classic and
Hummingbird Gliders
Assembly Instructions
Base Parts List
1 - (A) Back Assembly
1 - (B) Seat Assembly
1 - (C) Head Board
2 - (D) End Piece Assembly
1 - (E) Center Cross Piece
Assembly
4 - (F) Glider Arm Assembly
2 - (G) Leg Assembly
6 - ⁄" x 4⁄" Bolts
4 - ⁄" x 4" Bolts
6 - ⁄" x 3⁄" Bolts
2 - ⁄" x 3" Bolts
8 - 2⁄" Screws
6 - 1⁄" Screws
18 - ⁄" Nuts
18 - Washers
Hardware List
INSTRUCTIONS: *Always match numbers/letters printed on each individual piece. (1 to 1, 2 to 2, A to A, B to B, etc.)
Step 1 - Fasten
headboard to back
assembly with six 1⁄"
screws.
Step 2 - Attach seat
and back assemblies
with four 3⁄" bolts.
Put one in top hole
on each end and two
in center. Secure each
bolt with a washer and
nut.
Step 3 - To assemble
glider base, attach
center cross piece to
end piece assemblies
with four 4⁄" bolts in
top. Insert four 4" bolts
in bottom, inserted
from bottom up. Secure
with washers and nuts.
Position back and seat
assembly to prepare
for Step 2.
Position center cross
piece and end piece
assemblies to prepare
for Step 3.
0 1 2 3 4 5 6 7
INCH
continued on back
F.
G.
E.
D.
C.
A.
B.

INSTRUCTIONS: *Always match numbers/letters printed on each individual piece. (1 to 1, 2 to 2, A to A, B to B, etc.)
Place your glider in your appointed spot and
enjoy relaxing on it for many years to come.
4' & 5' Classic and
Hummingbird Gliders
Assembly Instructions
Step 4 - Remove one
washer and nut from
each end of glider
arm assembly. Attach
one end of glider arm
assembly to each
pre-drilled hole in end
piece assembly. Fasten
with washer and nut.
Step 7 - Put a 4 ⁄ "
bolt in back leg and 3
⁄ " bolt in front leg.
Secure each bolt with
a washer and nut.
Step 8 - Put a 3" bolt
through armrest into
seat back. Secure each
bolt with a washer and
nut.
Step 9 - Install 2 ⁄ "
screws in each pre-
drilled hole in leg
assembly.
Step 5 - Align the other end
of glider arm assembly to
bottom holes in leg assembly.
Fasten with washer and nut.
Make sure the small
part of armrest is
pointed towards the
long end of base.
Step 6 - Slide seat
and back between
armrests.