Euro Kitchen Appliances 3503B2-30 User manual

READ AND SAVE THESE INSTRUCTIONS
Range Hood User Guide
Euro Kitchen Appliances Inc.
Delta, BC Canada
www.KitchenHoods.ca
tel.[phone]
Model – 3503B2-30
The manufacturer disclaims all liability for any damage or injury
caused as a result of not following instructions for installation
contained in the following text.
The cooker hood is used on 120V/60Hz.

CONTENT
1…………………………IMPORTANT SAFETY INSTRUCTION
2………………………………INSTALLATION INSTRUCTION
3…………………………………….…….…………….. FEATURE
4…………………………………….………………..…………USE
5……………………………………….…………MAINTENANCE
6……………………………… ABNORMITY AND SOLUTION
7. ……………………………………………..WARRANTY CARD

(1) IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer.
b) Before servicing or cleaning unit, switch power off at service panel and
lock the service disconnecting means to prevent power from being switched
on accidentally. When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the service
panel.
CAUTION - For General Ventilating Use Only. Do Not Use To Exhaust
Hazardous Or Explosive Materials And Vapours.
WARNING - To Reduce The Risk Of Fire Or Electric Shock, Do Not Use
This Fan With Any Solid-State Speed Control Device.
WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE
FIRE:
a) Never leave surface units unattended at high settings. Boilovers cause
smoking and greasy spillovers that may ignite. Heat oils slowly on low or
medium settings.
b) Always turn hood ON when cooking at high heat or when flambeing food
(i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe’).
c) Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan or filter.
d) Use proper pan size. Always use cookware appropriate for the size of the
surface element.
WARNING – TO REDUCE THE RISK OF INJURY TO PERSONS IN
THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING
a
:

a) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray,
then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the
flames do not go out immediately, EVACUATE AND CALL THE FIRE
DEPARTMENT.
b) NEVER PICK UP A FLAMING PAN – You may be burned.
c) DO NOT USE WATER, including wet dishcloths or towels – a violent
steam explosion will result.
d) Use an extinguisher ONLY if:
1) You know you have a Class ABC extinguisher, and you already
know how to operate it.
2) The fire is small and contained in the area where it started.
3) The fire department is being called.
4) You can fight the fire with your back to an exit.
(2) NOTICE OF INSTALLATION
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes and standards, including fire-rated
construction.
b) Sufficient air is needed for proper combustion and exhausting of gases
through the flue(chimney) of fuel burning equipment to prevent back
drafting. Follow the heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire Protection Association
(NFPA), and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
d) Ducted fans must always be vented to the outdoors.

WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.
CAUTION - To reduce the risk of fire and to properly exhaust air, be sure to
duct air outside - Do not vent exhaust air into spaces within walls or ceilings
or into attics, crawl spaces, or garages.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for
the electric current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
WARNING – Improper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding instructions are not
completely understood, or if doubt exists as to whether the appliance is
properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a
qualified electrician install an outlet near the appliance.
(3) INSTALLATION PROCESS
a) The cooker hoods shall be placed at a
distance of 77-85cm from the cooking surface
for best performance. See Pic1.
b) Drill three Ø8 mm holes in a horizontal line
every 100 mm at the appropriate height for
installation of the mounting bracket.
c) Insert expansion bolts into the holes.
1
Pi c
77
85
c m
c m

d) Fix the mounting bracket on the wall(Note: The hood can be installed on
both wood wall and brick wall), then secure the cooker hood to it, see Pic2.
e) Install the metal duct onto the vent, and vent it outdoor, see Pic3.
f) Put the two-pieces U-shaped duct cover on the cooker hood, then adjust
the inner duct cover to the appointed height, see Pic4; drill two Ø8 mm holes
in a horizontal line for installation of the other mounting bracket and then fix
the bracket as instructed in Step (c) and (d); Secure the duct cover to the
mounting bracket by tightening the two screws, see Pic4.

(4) FEATURE
1. The cooker hood uses high quality materials, and is made with a
streamlined design.
2. Equipped with large power low noise electric motor, centrifugal leaf
which produces strong suction with low noise, and non sticky grease filter.
Easy for cleaning.
3. Equipped with the isolated low voltage circuit board control, 12VAC
input, the lights are therefore safe.
4. Special wind tunnel construction and oil collector design, free dirt will
be absorbed in a second.
(5) USE
1. Push stop button, and the motor will stop.
2. Push the Low button, and the motor runs at low speed.
3. Push the Mid button, and the motor runs at mid speed.
4. Push the High button, and the motor runs at high speed.
5. Push the light button and the two lights will come on. Push it again and
the light will turn off.

(6) MAINTENANCE
6.1 THE CLEANING OF THE CARBON GREASE FILTER MESH
The filter mesh is made of high-density stainless steel. Please do not use the
corrosive detergent on it. Keeping this filter clean will keep the appliance
running correctly. Please strictly follow the guidelines below.
METHOD 1 : Put the mesh into 40-50°C clean water, add detergent and soak
for 2-3 minutes. Wear gloves and clean with a soft brush. Please do not apply
excessive pressure or it might be damaged.
METHOD 2: If instructed to do so, it can be put into a dishwasher, set the
temperature at around 60°C.
6.2 NOTICE OF CLEANING COOKER HOOD
A. To protect the main body from corrosion over a long period of time,
the cooker hood should be cleaned with hot water plus non-corrosive
detergent every two months.
B. Please do not use abrasive detergent as it will damage the body.
C. Keep the motor and other spare parts free from water, as this will
cause damage to the appliance.
D. Before cleaning the appliance please remember to cut off the power.
E. The carbon filter shouldn’t be exposed to heat.
F. Please don’t tear the fixed bar around the carbon filter
G. If the plug or cord is damaged, please replace it with special soft cord.

(7) TROUBLESHOOTING
Fault
Cause Solution
The leaf blocked Get rid of the blocking
The capacitor damaged Replace capacitor
The motor jammed bearing
damaged
Replace motor
Light on, but motor
does not work
The internal with of motor off or
a bad smell from the motor
Replace motor
Beside the above mentioned, check the following:
Light damaged Replace lights
Light does not work,
motor does not work
Power cord looses Connect the wires as per
the electric diagram
Damper and the air
ventilation entrance are not
tightly sealed
Take down the Damper
and seal with glue Oil leakage
Leakage from the connection
of U-shaped section and
cover
Take U-shaped section
down and seal with soap
or paint
The leaf damaged and causes
shaking
Replace the leaf
The motor is not tightly
hanged
Lock the motor tightly
Shake of the body
The body is not tightly
hanged
Fixed the body tightly
The distance between the
body and the gas top too long
Readjust the distanceInsufficient suction
Too much ventilation from
open doors or windows
Choose a new place and
resemble the machine
The fixing screw not tight
enough
Tighten the fixing screw
and make it horizontal
The machine inclines
The mounting screw not tight
enough
Tighten the mounting
screw and make it
horizontal
(8)WARRANTY
CARD

We will warrant this product free from defects in material and quality for one
year from date of purchase. If any problems occur from correct usage, please
contact the service department for under warranty service.
This warranty does not cover the following:
The filter mesh and bulb.
Commercial use.
Amendment of the manufacture date on the rating plate.
After 12 months from date of purchase.
Damaged caused to the body by usage of detergent sprayer.
Pollution made to the led parts, glass parts and S/S parts.
Incorrect installation, misuse, abuse or neglect.
Incorrectly fitted to insufficient or unsuitable power.
Damage caused by foreign object.
Taken apart or serviced by unauthorized service engineers or replaced with
other manufacture’s components.
For commercial use the maintenance and free service should be discussed
with our authorized agent.
Beyond the 12 months warranty period, the purchaser should pay for charge
of components and call out.
In the event of a service call, please provide the warranty card and receipt of
date of purchase.
Manufactured for:
Euro Kitchen Appliances Inc.
----------------------------------------------------------------------
#111-590 Ebury Place
Delta, BC
V3M6K7 , Canada
www.KitchenHoods.ca