Euromair Mixpro 28 2021 Version How to use

1 / 2
Edition of 04/05/2021
Starting upStarting up
Mixpro 28Mixpro 28- 2021 version- 2021 version
• Apply silicone spray to the rotor (never use lubricant or grease), screw it into the stator with the propeller as far as it will go. Then
turn the motor a quarter turn in the opposite direction and close it.
• Connect the electric plug, turn the main switch to ON.
• Check that the water pump is not blocked. Unblock it if necessary.
• Check the position of the buttons and the thermal circuit breaker of the compressor.
AStop FPower on
BStart / Error acknowledgement GProduct selection (Powder - Paste)
CWater rise HCompressor start (Manual - Automatic)
DSpeed control IWater pump selection (Manual - O󰀨 - Automatic)
EIndicator light JReverse gear
• Connect the water (minimum 2 bars on the network) and prime it: Open the side valve and put the pump in MANUAL position, when
the water comes out without air regularly, close the valve and put the pump button on 0 (or in auto if less than 4 bars on the network)
• Connect the control hose.
• Open the water ow control valve (loosen 2 turns) and press the water lift button for 5 seconds.
• Start the machine and let the water ow out of the hose (set the desired water ow). When the water comes out of the hose, turn
o󰀨 with the remote control. Make sure the machine is running normally.
• Make an upow of water (about halfway up the chamber).
• Connect the product hose to the side outlet and turn on the water to moisten it. When the water comes out, turn o󰀨 the water and
empty the water from the hose.
• Break 2 bags of product.
• Insert the adjustment hose to adjust the consistency (or perform the operation directly on the product outlet).
• Clean the adjustment hose with the side outlet.
• Install the hose and pole (if equipped)
• Put the machine in AUTOMATIC mode, start it with the remote control and let the product come out of the nozzle.
• When the product comes out of the lance, cut o󰀨 by remote control.
• Apply product (machine must always be full)
• Apply the oor-screed.
A B
F
I JHG
C
D E

2 / 2
Edition of 04/05/2021
CleaningCleaning
Mixpro 28Mixpro 28- 2021 version- 2021 version
• Remove the pole.
• Run the machine to empty as much product as possible.
• Switch o󰀨 the machine, make a slight upow of water (about 4 cm)
• Open the motor and drop the remaining powder into the tank.
• Close the motor and reconnect the plug.
• Rinse the tank with water.
• Switch on, water ow rate set at 150. Stop operation when the tank is empty.
• Put the shaft and the cleaning tool on → drop the powder again and rinse with
water again.
• Switch on, water ow rate set at 150. Stop operation when the tank is empty.
• Clean hose: 2 x 2 cleaning balls on side water outlet.
• Clean the accessories.