EverFocus EV-RM30 User manual

EV-RM30
1. Introduction
The EV-RM30 is a TPMS receiver box with RS-232 Interface designed
to integrate the TPMS solution with the Mobile DVR. The EV-RM30
can transmits matched TPMS sensors’ signal, allows matching TPMS
Sensor ID through Bluetooth or BTU.
2. Packing List
•EV-RM30 x 1
•Quick Installation Guide x 1
•10m antenna extension cable
•Cable tie
•Adhesive lined polyolefin tubing
•Cable holder
3. Specification
Model Name
EV-RM30
Wireless Range
20m
Interface
RS-232
Frequency
433.92MHz
Operation Voltage
9 ~ 30VDC
Operation Current
40mA
Operating Temperature
-40°C ~ 85°C / -40°F ~ 185°F
Dimensions
97.9 x 58 x 17mm / 3.85"x 2.28"x 0.66"
4. Installation
1. Connect the power cable to the 9 ~ 36V battery power, red wire
to ACC power and black wire to GND, orange TX wire to the RX
wire of the Mobile DVR, white RX wire to the TX wire of the
Mobile DVR.

EV-RM30
2. Connect the antenna cable with the supplied 10m antenna
extension cable.
3. Wire the antenna extension cable along the vehicle’s body wiring
to the chassis that near the rear wheels.
Antenna
Extension
Cable Cable Tie
4. Fix the antenna using the supplied Cable tie. Do not twist the
antenna cable and make sure the antenna does not touch any
metal parts.
Cable Tie
Antenna
Extension
Cable

EV-RM30
5. For closed chassis, fix the antenna using the supplied Cable
holder. When use screws to fix the Cable holder on the chassis,
make sure to prepare screws of proper length in avoiding
damage of the oil tank.
Cable
Holder
Antenna Extension Cable
Cable Holder
Antenna Extension Cable
6. Use the supplied Adhesive lined polyolefin tubing to secure the
antenna connector.
7. Fix the receiver box in the vehicle, near the middle-front of the
rear tires using cable ties.