EverFocus 1/3" B/W CCD Camera None User manual

V. Specifications
INSTRUCTION
MANUAL
XThe following diagram shows the location for the other cameras.
YFix the camera by the screw. Tear off the black paper of the
corresponding view window where the lens faces to.
ZRepeat steps 3 to 6 in the Installation Instructions.
For B/W CCD
Camera
For B/W CCD
Camera
For B/W CCD Camera
For B/W CCD
Camera
For B/W CCD
Camera
1/3” B/W CCD Camera
FCC/CECertifications
0°C to + 50°C ; 32°F~122°F(20%~80% Humidity)Operating Temperature
0.283kg ; 0.62lbsWeight
150 mm (O.D.) x 50 mm (H) ; 5.9" (O.D.) x 2" (H)Dimensions
3W max.Power Consumption
12VDCPower Source
M12 x P0.5Lens Mount
Internal Sync.Sync. Mode
BNC 1.0Vp-p,75 ohmVideo Output
0.45Gamma Correction
YesBack Light Comp.
1/50(1/60)~1/100,000Electronic Shutter
Over 48 dB (AGC off)S/N Ratio
0.04 Lux/F=1.2Sensitivity
420 TV linesHorizontal Resolution
510 x 492 (EIA)
500 x 582 (CCIR)
Picture Elements
1/3" SONY B/W CCDPickup Device

III. Installation Instructions
1. The horizontal view angle of the Smoke Detector Camera is
78-degree. Decide the location to install the camera.
II. Precautions
•Do not expose the camera to humidity and dust. Outdoor
application without shielding is not recommended.
•Handle with care. This camera consists of sensitive high
precision parts. Do not disassemble or install it on an
unstable base.
•Operate on +12VDC. Use a regulated power source only.
•Never face the camera toward the sun directly.
P/N: MSM1G0030A VerB
4. Connect the video output of the camera to a monochrome monitor
or other video device through a 75 ohm type coaxial cable with
BNC female connector at cable extension.
5. Connect the +12VDC regulated power source of the camera to
the DC 12V Power-in jack with 2mm, center+, outer-plug.
6. Adjust the direction of the lens as per needed.
I. General
This camera is smoke detectors built with B/W CCD cameras
for discreet surveillance. It comes with B/W CCD camera that
delivers clear and sharp picture for side viewing; and it is easy
to change different lenses to adopt the best view angles for
security need. This camera can simultaneously install up to 4
cameras, which is most economic and effective for video
surveillance.
IV. Installing More Cameras
This camera can accommodate up to 4 B/W CCD cameras. Please
refer to the following steps to install the other cameras.
2. Visually inspect the contents to ascertain that no damage
occurred during shipping.
3.Plug in the attached video and power cable to the camera
connector.
Full-Screen Width of View
= 1.6 XDistance between
Camera and Target
78°