
- 1 -
1. Introduction
The SA370 is a Z-Wave™USB adapter to turn the PC or gateway into a
Z-Wave controller to manage multiple devices in the Z-Wave network. It
adopts the latest Z-Wave 700 series technology from Silicon Labs to fulfill
requirements for Z-Wave Plus™v2 certifications.
A Silicon labs driver “CP210x Drivers”and third party software are required to
operate this device. A PC / notebook running Z-Wave software can then
control Z-Wave network through this USB adapter.
Note: This is a hardware transceiver only. Third party software needs to
be installed on your computer before using as a Z-Wave Gateway.
Simply plug the USB dongle into your PC or notebook and install all
necessary drivers and software.
Specifications
Operating Temperature Range
-10 to 50°C (Indoor use only)
Storage Temperature Range
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Industry Canada statement:
This device complies with ISED’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.