Evolio Evobook3 User manual

Evobook3
USER MANUAL

EVOBOOK 3 User Manual
i
Safety Precautions
On Battery
Charge the battery only in temperature that ranges
from 0 to 35 degree Celsius.
Do not charge reader if the battery is found damaged
or leaking.
On Operation
Never subject reader to extremes of light, temperature,
moisture or vibration.
Do not use or store reader in a location subject:
A. Extreme high temperature, such as in a sun-heated car
B. Direct sunlight
C. High humidity or places with corrosive substances
D. Sub-zero condition, especially during winter.
. On micro SD card
After inserting a micro SD card, if the reader has no
response, please take out and insert again.
Do not remove micro SD card or turn off reader during
data writing or reading to prevent damage to data and
to the reader.
Make sure the micro SD card is unlocked before
writing or deleting data in the micro SD card.
Backup your files and data before formatting the micro
SD card. Please format the micro SD card in FAT.

EVOBOOK 3 User Manual
ii
Contents
SAFETY PRECAUTIONS ...........................................I
CONTENTS................................................................ II
CHPATER 1 BASICS.............................................1
PARTS AND CONTROL .........................................1
POWER ON AND OFF THE READER .......................2
CHARGING THE READER .....................................3
IMPORTING CONTENTS ........................................4
IMPORTING DRM CONTENTS ..............................5
HOME SCREEN ..................................................10
MAIN MENU .....................................................11
ONSCREEN KEYBOARD......................................14
CHPATER 2 GETTING STARTED........................15
READING BOOKS...............................................16
VIEWING PHOTOS..............................................22
FILE EXPLORER ................................................24
CHPATER 3 SETTINGS .....................................24
POWER SETTINGS .............................................25
DATE &TIME...................................................25
SYSTEM LANGUAGE .........................................25

EVOBOOK 3 User Manual
iii
FORMAT DEVICE ..............................................25
RESTORE DEFAULT SETTINGS ............................25
DEVICE INFORMATION ......................................25
DRM AUTHORIZATION INFORMATION ...............25
CHPATER 4 TROUBLESHOOTING ...................25
CHPATER 5 APPENDIX .....................................26
MAINTENANCE .................................................27
PRODUCT SPECIFICATIONS ................................27
CERTIFICATION INFORMATION..................ERROR!
BOOKMARK NOT DEFINED.
COPYRIGHTS AND TRADEMARK NOTICE ...ERROR!
BOOKMARK NOT DEFINED.
DISPOSAL AND RECYCLING INFORMATION ERROR!
BOOKMARK NOT DEFINED.
DISCLAIMER. ERROR!BOOKMARK NOT DEFINED.

Chapter 1 Basics
1
Parts and Control

Chapter 1 Basics
2
Clip slot –to insert the clip button for protective cover.
Power button –press and hold for 3 seconds to turn on/off.
Press and hold for 3 seconds to restart.
Enter button
–: the directional buttons, press up/ down/
left/ right to move cursor.
–Enter button: Press to confirm or cancel.
Home button –press to return to home screen.
Menu button –press to display option menu.
Return button –press once to return to previous menu,
press and hold to return to Main menu.
Keyboard button –press to display/hide the keyboard.
Micro USB jack –for data transfer and emergency
charging.
Power On and Off the Reader
Press and hold the Power button for 3 seconds to turn
on reader.
It may take a few moments for reader to turn on and
load the content.
If Reader does not turn on, charging is required.
To turn off reader, press and hold the Power button for 3

Chapter 1 Basics
3
Seconds again.
Charging the Reader
You need to charge the reader prior to using it for the first
time or when battery power is low.
Charge the reader using AC adapter with output 5V,
1.5A.
Charging through PC may not be able to fully charge the
reader due to the low output charg
ing current from PC USB port.
Please turn the reader to standby mode to shorten the
charging process.
It will take about 4 hours to fully charge the reader in
standby mode .
When the reader enters into standby mode, press the
Power button to wake up the reader.
The battery status is displayed at the bottom left corner.
The status is shown as below:
Low battery Charging Battery full

Chapter 1 Basics
4
Importing contents
From Computer
The Reader supports USB Mass Storage Device
function.
To import contents (ebooks, photo etc) into the reader,
connect the reader to PC via the supplied USB cable.
Upon successful connection to PC, the reader will enter
USB mode and all operation will be halted.
Go to [My Computer], double click on the reader’s disk to
open.
Perform the file management operation like USB device.
From memory card
This unit supports micro SD card up to 32GB.
To insert a memory card
Insert the card correctly with the contact pin facing
downwards as illustrated below. Pushing the card in, then
you should hear a click when the reader is seated correctly.
You may damage the card and the reader if micro SD card is
not inserted correctly.
To remove micro SD card, push the card once again until it
contact the back of the slot.

Chapter 1 Basics
5
When the card is inserted or removed, it will take several
seconds to load.
Please avoid inserting or ejecting the card when other
operation is running as this may cause the system hang.
Do not remove the card if the content inside the card is being
played. This will halt the operation of the reader and cause
the reader to restart.
Importing DRM Contents
The Reader supports Adobe DRM contents. Adobe Digital
Editions (ADE) is required.
Installing Adobe Digital Editions (ADE)
The ADE installer is preloaded into the computer.
Make sure your computer is connected to internet.
Double click on the ADE installer file to start the
installation.
Alternatively, you can download the installer from
http://www.adobe.com/products/digital-editions/download.e
du.html.
Authorizing PC and Reader
Authorizing your PC and reader with an authorization ID
enables you to easily transfer Adobe DRM protected items
between your ADE library and this device.
Launch the Adobe Digital Editions (ADE).

Chapter 1 Basics
6
Connect the reader to computer, make sure it is in USB
mode(Data transfer mode), ADE will automatically detect
the presence of your device.
The reader will be recognized in “Devices”at the top left
of ADE window.
To authorize PC and reader, click on Devices
“EVOBOOK 3”Authorize Device, as the
below figure shown:
After authorization, you will be able to find the Reader
content recognized in ADE. Click on Devices
“EVOBOOK 3”, contents inside the Reader will be
displayed on the right of windows.