EVZEN ELITE AVENZOR EVZ5 User manual

ELITE
Instruction Manual
AVENZOR EVZ5 Wireless Controller
PS5 PRO CONTROLLER
ACUH-ZCT2B EVZ5
®

Control Panel
The Avenzor Controller for Ps5tm has a control panel, where you can adjust
sensitivity, paddles operation, range and also the paddles remap.
Access the Control Panel
To access the control panel, you must remove the cover with the Evzen logo,
using the screwdriver that comes with the kit.
Insert the screwdriver in the location shown in the image below and apply a
little force toward the outside of the controller, so then the cover should
come off.
Screwdriver
Opening Area
EN
2

Ajustments Map
Remapping System
Mechanized Method
Height Limiter
Opening Screws
Mechanical Remap System
Remapping is simple, with the panel open, just use the screwdriver in the
point that you want adjust and turn until you find the desired option.
You can choose among four adjustment options on each paddle. Use the
guide below as a reference.
Guide
3

Operation Adjustment
Operation Mode
The Avenzor paddles work with two modes of operation, both are mecha-
nical and without any digital resources, so you can have zero delay.
To adjust, the L key accompanying the controller will be necessary.
Mode 1 Free Mechanized
In the Free mode, the paddle is free of material tension force. It work only
with the gravity force, giving a lighter sensation to the user.
To activate the free mode, you must turn one of the screws highlighted
below counterclockwise so that the configuration screw does not lock the
paddle, each of the four screws configures 1 paddle.
Mode 2 Mechanized by Tension
In the tension mode, the paddle is locked and every click movement is made
through the lust and flexibility of the paddle, making the click more rigid.
To activate this mode, it is necessary to turn one of the screws highlighted
in the clockwise until it touches and presses the paddle.
L Key
4

With the range limiter the paddle recoil is less, the turn after the click
is decreased.
Range and Sensitivity Limiter
Range Limiter
To configure the range, turn the screw on the desired paddle, just like
indicated in the illustration to adjust, turning clockwise the range decreases
and on the reverse side it increases.
Sensitivity adjustment is a feature that is only available for controllers
configured with stage zero limiter, at which point the adjustment screw
touches the paddle.
Sensitivity Adjustment
With adjustment screw in stage zero, you turn clockwise to decrease sensitivity.
In this setting, a pressure load is played over the button, leaving it semi
clicked, thus making it more sensitive.
To make the adjustments you will need the L key that comes with the control.
Sensitivity Adjustment
and Range Limiter
L Key
5

With the cover removed, you must remove the screws that hold the base.
Changing Paddles
Remove the Control Panel
To change and adjust the paddles, you will need the L key that
accompanies the control.
L Key
Panel Screws
Removing and Changing Paddles
6

*For Controllers Mounted with Two Paddles
Factory-mounted controllers with two paddles come with a protective vinyl
in the slot of the central paddles.
To install the four paddles, remove the vinyl by pulling one of its ends to
detach it.
7

Extra - Special Adjustment Option
Some Avenzor controllers have an extra adjustment below the paddles
this adjustment works creating a distance between the paddle and the
button leaving less sensitive.
To adjust you must remove all paddles and insert a screw
that comes in the Avenzor accessory box, rotating
until the screw enters inside the base of the controller, after fixing it in the
place you can adjust the height it will be rotating counterclockwise.
L Key
Adjustment Screw Slot
8