Extend My Seat RAV4-D User manual

Toyota RAV4 Driver Side
Extender Guide
INSTALLATION GUIDE RAV4 (2006-2011)

Installation Guide: Thank you for purchasing extendmyseat (EMS) brackets.
Please follow the directions carefully and within 30 minutes you will be loving
your new seats.
Inventory in Box:
2 - extendmyseat brackets
2- black 3/8 stainless bolts
2 - stainless 3/8 bolts
What you will need for assembly:
1- socket wrench
1- Metric 14mm socket (Prius uses metric however a 9/16 works)
1- protective eyewear
Step 1- Remove the Black extendmyseat brackets from the packaging and locate
the clear bolt baggie.
Step 2- Go to your vehicle with a socket wrench and a metric 13 socket, eye
protection and your keys. Remember to turn off your cabin lights.
Step 3- Locate the 4 factory bolts that hold your seat to the vehicle. Take your
socket wrench and loosen the 4 factory bolts. (2 in the front and 2 behind your
seat, go to rear seat to locate) Remove the 2 plastic guards to locate the 2 rear
factory bolts. Remove the 4 factory bolts and set them aside
INSTALLATION GUIDE RAV4 (2006-2011)

Step 4- (Optional Step. You do
not have to unplug the cables)
Unplug the 3 factory cables
plugged into your car seat
under the front portion of the
seat. No tools required.
Remember to plug these back
in after you have completed
the install.
(YOU MAYALSO CHOOSE TO NOT UNPLUG THE CABLES AND LAY THE
SEAT ON THE REAR SEAT OF THE VEHICLE, SKIP TO STEP 7)
Step 5- Remove your car seat carefully. (approximate weight is 25 pounds)
Step 6- Place your driver’s seat on a bench or on the ground on a clean sheet,
towel etc...(don’t want to et it dirty)
Step 7- Grab the 2 extendmyseat brackets
INSTALLATION GUIDE RAV4 (2006-2011)

Step 8- Lay down the 2 black brackets
inside your vehicle and line up the 4
hole locations. The parts look similar
however the 90 degree bends on the
brackets need to be facing the out.
(see photo)
Start with the front 2 holes. Finger
tighten the 2 factory bolts into the 2
front EMS bracket holes. Now line up
the 2 rear holes and finger tighten the
2 remaining factory bolts. Finger
tighten all 4 holes with seat still out.
o
Step 9- Place the seat back into the
vehicle. Line up seat front holes with
EMS front holes. Finger tighten front
2 feet with provided black EMS bolts.
Press seat lever and slide seat to the
most up front position. Go to back
seat and screw down the remaining 2
factory feet with the stainless EMS
bolts.
INSTALLATION GUIDE RAV4 (2006-2011)

Step 10- Make sure all 8 bolts are tight.
Step 11- Test the seat by sliding the seat back and forth.
Step 13- Last step is to make sure you have reconnected the 3-airbag and seat
sensors. Enjoy!
INSTALLATION GUIDE RAV4 (2006-2011)