Extron electronics TP Receiver User manual

Setup Guide — TP Receivers
This card provides instructions for an experienced
installer to set up and operate the TP Receiver Series
products.
Refer to www.extron.com for the complete user’s
manual.
Pre-installation — Jumper settings
The TP R BNC A and TP R BNC AV are factory configured to receive
RGB video. They can receive component, S-video or composite video
by changing jumper J3 located on the main board.
NIf using the TP R BNC AV with an older TPX 88X transmitter,
download the TP Receivers User’s Manual at www.extron.com
and refer to the audio jumper settings.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources
and mount the receiver as required.
Step 2 — Connect input
Connect the RJ-45 cable (from a TP transmitter)
to the Input port on the TP R.
Terminate the ends of the cable to the same
standards.
Step 3 — Connect outputs
Attach the applicable output cables (video, audio),
depending on the TP R model.
a. Composite video output connector — Connect to the single female BNC
connector (VIDEO) for composite video output (TP R BNC AV Only) or to
either the R, or G, or B connectors (TP R BNC A Only).
b. S-video output connector — Connect to the R (C-chroma) and G (Y-luma)
connectors.
c. Component video — Connect to the R (R-Y), G (Y) and B (B-Y) connectors.
d. RGBHV Video — Connect to the R, G, B, H, V connectors.
e. RGBS video — Connect to the R, G, B, H/V connectors.
f. High resolution video output connector — Connect to the 15-pin HD
connector (TP R 15HD A only).
g. Audio connector — Connect an audio device accepting line level analog
audio to the unbalanced stereo audio RCA connectors (TP R BNC A and
TP R BNC AV) or to the line level stereo 3.5 mm, 5-pole captive screw
connectors as shown.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
NOTE If using Enhanced
Skew-Free™ A/V cable, use th
e
TIA/EIA T568A standard only.
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Side
Blue Blue
Insert
Twisted Pair
Wires
Pins:
12345678
RJ-45 Connector
C For unbalanced audio, connect both sleeves to the center (ground
)
contact. DO NOT connect the sleeves to the negative (-) contacts.
Unbalanced Output Balanced Output
Do not tin the wires!
Tip
Ring
Tip
Ring
L R
Sleeves
NO GROUND HERE
NO GROUND HERE
Tip
Tip
L R
Sleeves
RGB
J3
1
2
3
Component,
S-video,
Composite
J3
1
2
3
Continued on other side

Step 4 — Power
Plug the included external power supply
into the 2-pole (TP R 15HD A) or 3-pole
(TP R BNC A) captive screw connector. Wire
the connector as shown and plug it into the
receiver. The front panel Power LED is amber
when power is present and green when signal
and power are present.
Step 5 — Set Rear Panel DIP Switches
2-position (TP R BNC A/AV), or 4-position (TP R 15HD A) switch (up = ON)
a. SOG — Sync on Green. Set this switch up for RGsB and down for RGBHV or
RGBS video.
b. C Sync — Set this switch up for RGBS and down for RGBHV or RGsB video.
c. C video (TP R 15HD A only) — Set this switch down (off) for RGB video or up
(on) for component/S-video/composite video.
d. N/C (TP R 15HD A only) — Not used.
Step 6 — Manual/Auto Switch
NThere are 2 sets of switches and controls (Video and RGB) on TP R BNC AV only.
Auto provides automatic signal level and peaking
compensation of the output for long cable runs.
Step 7 — Peaking and Level Adjustments
Manual compensation for long cable runs can be made by the user
with the Auto/Manual switch in the Manual position.
Image sharpness is adjusted with the Peaking Control. Increased peaking compensates
for mid- and high-frequency detail loss. Minimum setting (full counterclockwise) is zero
peaking.
Image brightness is adjusted using the Level Control which increases the video signal
output voltage to boost brightness.
While viewing the display, adjust either or both controls for the best image quality.
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
Setup Guide — TP Receivers, cont’d
68-547-50
Rev. A
01 09
SECTION A–A
Power Supply
Output Cord
Ridges
Smooth
A A
TP R 15HD A
3/16” (5 mm)
Max.
TP R BNC A
N/C N/C
Typical TP R application
TP R BNC AV
VIDEO
MANUAL
AUTO
LEVEL PEAKING
RGB
MANUAL
AUTO
LEVEL PEAKING
C SYNC SOG C VIDEO N/C
ON
SOG C SYNC
TP T 15HD A
TP R BNC A
TP T 15HD A
H-SHIFT
BUFFEREDCOMPUTER
INPUT
AUDIO
ID PIN 4
ID PIN 11
LOCAL MONITOR
PC
CAT 5 UTP Cable
Audio
Projector
RGB INPUT RGB OUTPUT
R G B H/HV V
A
AUDIO
L
R
B
SOG
C SYNC
POWER
15V.5A DC
LR