EZ-ON 43YC User manual

43YC
CAR CAM WITH CROTCH STRAP
IMPORTANT INFO
• Meets FMVSS213
• 43YC is for use by a passenger weighing 31 – 106
• You must use EZ-ON hardware tether kit (included) to install this conversion vest if the factory
installed tether anchor weight limit is less than the weight of the passenger or if there is no
tether anchor point available in your vehicle.
• Register this product to be notied for a safety recall
EMERGENCY RELEASE PROCEDURE
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com
WARNING
Death or serious injury can occur If manufacturer’s instructions are not followed correctly.
All EZ-ON products are dynamically tested to meet NHTSA standards. Please follow washing
instructions on product tag. Replace product if it is damaged, frayed, or has been in a crash.
Recommended replacement after six years.
EZ-ON Products are not liable for injury if these recommendations are not followed.
WARRANTY
EZ-ON Products stands behind the products we make. Warranty covers any defects in material or workmanships under
normal use during the warranty period. We will repair or replace product defects for 1 year from manufacturer date.
When evacuating a passenger in an 43YC belt,
one cut of the lap belt will allow the passenger to evacuate the vehicle.

1-800-323-6598
www.ezonpro.com
INSTALLATION INSTRUCTIONS
1. Locate the tether anchor bracket.
*Check the vehicle owner’s manual to
locate factory installed tether bracket.
*43YC tether strap can be turned one half
twist to snap on difcult anchor locations.
2. Connect tether hook to tether anchor
bracket directly behind passenger.
Twenty degrees from “Y” center is
acceptable.
* Tighten by pulling on black webbing so
Y-bridge sits on seat top.
3. Prior to the child sitting down, place all
of the straps on the front of the seat.
Make sure the gray strap is laying across
the bottom of seat cushion.
4. Sit passenger on the gray strap, so that it
extends forward from between the
passenger’s legs. Place the adjustable
black straps in front of the passenger’s
body.
5. Thread the vehicle lap belt through the
rst chest strap, then the gray crotch
strap, and then through the second
chest strap.
6. Buckle lap belt and tighten.
7. First adjust the gray crotch strap from
the top of the seat, by pulling on the
loose webbing.
8. Adjust the shoulder straps by pulling
down on the loose webbing.
* Do not shorten the shoulder straps too much.
This can cause the lap belt to be over the stomach
causing injury.
9. Clip chest clip, and position at armpit level.
12
34
56
78
9
43YC
CAR CAM WITH CROTCH STRAP
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com