EZM FG-100 User manual

1. Press the power switch (POWER) button to turn on the power, then the power
LED and LCD backlight lit simultaneously.
2. After boot, LCD cursor position in a hundred K frequency flicker.
Then you can use the +, - keys to adjust the value, which is to adjust the frequency.
Each press of the cursor (CURSOR) button, the cursor moves to the right one. Bit
value blinking cursor can be used +, - keys to adjust the value. When the value of
the desired frequency adjustment is completed, press the operation is stopped
(RUN / STOP) button, the cursor disappears, it will generate a waveform output. To
obtain the desired waveform, you can press the "RUN / STOP" key, then the cursor
appears, click on each mode (MODE) button will change one of these waveforms.
After the waveform information to be displayed, press the "RUN / STOP" button, it
will output the desired waveform.

3. Filter button (FILTER) to use, in the case of a sine wave, press this key, reduces
distortion sine waveform smoother. In addition to the case of square wave, other
waveforms may also be filtered according to the actual function. In the case of a
square wave, if you are using filtering function waveform edges will be significantly
slower.
The DC offset (DC OFFSET) used, in the case where the DC offset is not used, the
output waveform is the zero level of symmetry. If you want such as the bottom of
the square wave is 0 level, you can press DC offset button, and then use the DC
offset potentiometer to adjust to the desired results. General DC offset button
should be lifted, that is turned off.
The file translated by google translate,may be hard to read,sorry for any trouble.
Any trouble, please contact [e-mail]