FairCape Woodworks Adirondack Glider User manual

Adirondack Glider Additional Assembly Instructions
!
1. Turn assembled Adirondack upside down on a flat table top as shown.
!
!
!
2.Attach base leg supports to front and base legs. Insert two 1¾” screws through
front (square end) of one base leg support until tips show. Also insert one 1¾” screw
and one 3” screw through back of base leg support as shown in the photo until the tip
of the 1¾” screw shows. Apply glue and line up screws to pre-drilled holes on inside
of front leg and bottom of base leg. Tighten screws. Repeat for second base leg
support on other side.
!!! !
Unpack and examine all additional parts,
which consist of:
1 each: Glider base frame with swing arms
2 each: Adirondack base leg supports
1 each: Additional hardware
1 each: Assembly instructions
NOTE: BOTH BASE LEG SUPPORTS ARE
LABELLED FOR CORRECT ALIGNMENT.!

!!! !
!
"#!$%&'!()*+%,)-./!01-*+!'%!2&*)3+!-+45!%6!7&*)3+!8+-43#!Turn!Adirondack!the!right!way!
up!and!place!it!over!the!glider!frame!with!the!‘FairCape’!nameplate!facing!the!front!of!the!
chair.!Insert!a!3’!bolt!through!the!hole!in!the!front!leg!and!the!glider!arm!in!the!following!
order:! 3”! bolt,! washer,! front! leg,! base! leg! support,! washer,! glider! arm,! locknut.! Use! two!
wrenches!to!tighten.!
!
!!! !!! !!! !
!
Use!2”!bolts!through!the!holes!in!the!back!of!the!base!legs!in!the!following!order:!2”!bolt,!
washer,!base!leg,!washer,!glider!arm,!locknut.!Tighten.!
!
!!!! !
!
!
!
Move!the!chair!with!two!people!picking!up!the!base!frame.!
!
9,:%;<!