FANATEC Sparco Pro 2000 User manual

QuickGuide
Sparco Pro 2000 Seat
www.fanatec.com

Thank you for choosing
This Quickguide explains the assembly of the Sparco Pro 2000 seat to the
Fanatec RennSport Cockpit V2.
ATTENTION
Please mount the seat rails to the RennSport Cockpit V2 seat plate rst.
This will provide you easier mounting than assembling the rails to the
Sparco seat rst.

3
Sparco Pro 2000 Seat
Mount the seat rails to the base plate with the broad side of the rails facing up-
wards and the end with two mounting holes in the upper side facing forward in
sitting direction (see picture below). Use the outer mounting holes for attaching
the rails to the base plate. Do not use washers on the inside of the rails.
You can adjust the position of the rails by pulling the lever on the rails upwards:
MOUNTING THE RAILS TO
THE SEAT PLATE
1

4
Sparco Pro 2000 Seat
After the assembly of the two screws in the front, adjust the rails forward and
mount the two screws in the rear:
ASSEMBLY OF THE SEAT
ADJUSTMENT BAR
2
For mounting of the seat adjustment bar, be sure both rails are in the same
position. The bend in bar handle should be tilting upwards. Place the holes in
the bar over the posts rst on one side. Then use a screw driver as a lever to
position the holes on the other side over the posts (watch out, don’t pinch your
ngers!):

5
Sparco Pro 2000 Seat
IMPORTANT: Make sure that the bar is securely positioned on the
posts of the rails as shown below. You might need to use a hammer to get
the bar attached on the rails properly.
ASSEMBLY OF THE SIDE
PANELS TO THE SEAT
3
Now mount the side panels to the side assembly points of the seat. You can ad-
just the seat angle to your individual preference by using the various mounting
holes on the side panels.

6
Sparco Pro 2000 Seat
Put the seat onto the rails and mount the two screws in the front rst. Use the
inner holes as marked below.
For the last step, adjust the seat fully backwards and mount the two screws in
the back:
MOUNTING THE RAILS TO
THE SEAT PLATE
4

Fanatec®is a registered trademark of Endor AG
Designed and developed by Endor AG in Germany
04/2016