Fancy Miracle H8002 User manual

Operation Manual
Juicer（Slow juicer）
Model：H8002
⚫Thank you for your purchase. Please read the instruction book carefully before the
product is used, and please use the machine according to the instruction book.
Please properly retained for reference because the continuous improvement of
products are subject to change without notice.
⚫The picture diagram only and could be similar as the product.
⚫The product is applicable to family use, and it is inapplicable to commercial use,
otherwise it’s service life may be shorten.
LOVAS

Table of Contents
Safety Notes （1）
Product Specifications （3）
Product Part Name （3）
Accessory Description （4）
Instructions （4）
Assembling Method （6）
Method of Usage （9）
Cleaning Method （12）
Troubleshooting （13）
Circuit Principle （14）
Service Description （15）
Warranty Card （16）

1
Safety Notes
【Prohibition】 【May lead to casualty】
【Enforcement】 【May lead to
injuries or property loss】
The product is applicable to family use, and it is inapplicable to commercial use.
Do not allow children to use appliance alone. Please keep it out of reach of
children. The elderly or people with disabilities and people without experience
should use this product under guardianship and guidance.
The continuous use time of the product should be control within 20 minutes.
Prohibited no-load or overload use during the operation of machine.
Please do not touch or move any moving part during the operation of machine.
Prohibit to put the power cord hang over some sharp object and do not connect to
some moving object.
Prohibit to use this product in an inclined surface or unstable table.
All the parts of machine are prohibited high-temperature baking in sterilizer or oven.
It is forbidden to use finger,spoon and chopstick to push fruits or vegetables into the
feed inlet of machine, but can use the pusher only.
If the parts of product structure is found to be damaged(particularly the safety device
and power line are damaged),please stop using and sent to the company's
maintenance departmet to maintian by professionals,so as to prevent accident.
Before the machine is cleaned, moved or if it is not used,please power off and pull
out the plug.
If the power line is damaged,it must be replaced by the manufacturer, or similarly
qualified persons in order to avoid accident.
Do not use unauthorised accessories because it may cause fire and injury.
Be carefully to watch it during the operation so as to prevent accident.
Please confirm whether the voltage has consistency with the product specifications
before use (220-240V~ 50Hz), so as to avoid a safety hazard and damage of product.
After using the product, clean the parts contact with food to avoid an odor from
corrosion residue.
For safety, to avoid loss or hurt to you or others, please be sure to
observe the following safety precautions
；If you do not follow the safety
precautions and wrong usage may lead to accidents. This product does not
consider the following
：Appliance used by children or the disabled. Children
play with the appliance.

2
If the fine strainer damage, do not use the appliance.
After using the product, please unplug the power in time and clean the product.
The case of this product can not be started. Please refer to "troubleshooting" Guide
page, if still can not be started, product should be sent to the company's maintenance
departmet to maintian, please do not disassemble by yourself.
This product is not available for crushing grain, ice, sugar, sugar cane and other hard
foods（Easily lead to stuck, mechanical failure）.
Please do not make the product used or place beside high temperature gas or electric
stove.
Lemon is unallowed to be put into the appliance,since it contains substance reacting
with material of the jucing system (which will get cracked).
This appliance is intended to be used in househlod and similar applications
such as:
- staff kitchen areas in shops, offices and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.

3
Product Specifications
Rating power：220-240V/50HZ
Item
Size（mm）
Power（W）
Rated Time
H8002
220*290*518
240W
Up to 20mins continuously
Product Part Name
Turnover Cap

4
Accessory Description
Name
Quantity
Name
Quantity
Name
Quantity
Cup
2
Pusher
1
Instruction
1
Cleaning Brush
1
Juice Cap
1
Remark: The actual product maybe a little different to the illustration.
Instructions
Product Features
⚫Non-grinding juicing method featured by slow squeezing is adopted for the
product, so the natural flavor and nutrient elements of fruits and vegetables are
well retained. The product has multiple functions, including making vegetable
juice and fruit juice, etc.
⚫The juice container can separated with the mainframe, and it is convenient for
cleaning.
⚫Dual-switch design, makes the product safer (make the juice container installed
onto the mainframe; apply the juicer cap of squeezing body, and then turn on the
switch to make the product run).
Precautions
* Please read the following contents before use.
1. Do not run the product for a long time, if the product runs more than 20 minutes,
please cool it for 20 minutes before continuing juicing, as to prevent damage to the
product.
2. The materials shall be put into the machine slowly one by one, and new materials
shall be put into it after the previous materials have been squeezed.
3.The materials with large fiber content(such as celery)shall be put into the machine
after being cut into the blocks with appropriate size(5-10cm).The materials with
particularly strong fiber shall be put into the machine slowly after being cut into the
blocks of about 3cm.
4. When the carrot that have been stored at low temperature for over 1 night then used
for squeezing, it is better to make it squeezed together with the materials with large
water (such as pear or orange),because that such carrot has small water. The juice
amount will be large if new materials are put into the machine after the previous
materials have been squeezed (the juice amount will vary with the water content of

5
materials).
5. The juice amount will be small if the materials are not fresh. When dry materials
stored in refrigerator are used for squeezing, the materials shall be squeezed after
being immersed in clear water for sufficient water absorption, so that the effect will
be better.
6. Hard materials are not applicable to make juice (such as kudzu, sugarcane, etc.).
7. There will be certain friction noise when carrot (hard flesh) or apple (hard peel)are
used for squeezing, but this has no impact on the product.
8. Juice will be splash from the feed inlet when such materials as cherry, tomatoes and
grapes are used for squeezing.
9. When squeezed lemons, oranges please be sure to remove peel and it is better to
remove seeds.
10. When squeezed harder fruits and vegetables, the product may be a slight shaking,
this phenomenon is normal, please feel free to use.
11. When squeezed darker pigmented fruits and vegetables, such as carrots, beetroot,
etc., there will be light colored with the plastic, it is a normal phenomenon.
12. Before use of the product please confirm juice cap is assembled in place.
13.The leftovers cannot put into the slow juicer again otherwise may cause
malfunctioning or failure to open the hopper.

6
Assembling Method
1. Please make sure the squeezing rubber pad has been installed right before
assembling the bowl.
①Make the squeezing rubber pad stuffed in a narrowly oblong hole.
②Make the squeezing rubber pad stoppered.
2．Make the bowl installed in the main body.
①Make the bowl inserted in the fixed point of the body.
*The marking line of bowl should be align with the marking line of body when
assembling. ②Then tightening with clockwise rotation.
3. Put the fine strainer into the spinning brush.

7
4 .Put the assembled fine strainer and
spinning Brush into the bowl.
*When installating,please make the marking
Point on fine strainer align with that on the bowl.
5. Make the Squeezing Screw installed into the bowl.
6.Install the hopper into the main body
When it is installed downwards,the marking point on hopper shall align with that
on the bowl.
Make at the back of the hopper rotate towards on bowl in clockwise
direction and lock.

8
7. According to the figure.Put the juice container and pulp container at the
appropriate position:one is used to receive juice,and another is used to receive
pulp(the two containers have the same overall dimension).
8.Juicer cap assembling method
The juice cap is split when packaging.Please put the juice cap to aim at the fixed leg,
then gently inserted.

9
Method of Usage
1. Turn on the switch (forward)
Forward：push down fruits and vegetables for juicing
Reverse: fruits and vegetables up return, to avoid
being stuck phenomenon occurs when the revolution
Warning:
1)Do not touch the switch with wet hands.
2)prohibit idling products before putting fruits and vegetables.
2. Put the clean fruits and vegetables (size of fruits and vegetables should be cut into appropriate size)into the inlet,
push with the pusher.
Warning：
1)Please choose the fresh fruits and vegetables.
2)Fruits and vegetables stored in the refrigerator for a long time
should soak in cold water for 10 minutes before use.
3)Fruits with hard core nucleus must be removed.
3. If the machine shutdowns suddenly when it is running,press the “Stop”buttom first and then press
the“Reverse”buttom.To make the food in the squeezing screw can up release and then press the
“Forward”buttom(Repeated 3 times）.
* When the machine is in reverse, gently press the lid with your hand(to prevent the lid loose).
*If the machine still not work, disassembling the machine and then wash before use.
* Please be sure to cut the food into thin strips like carrots and other hard materials,or it may cause stuck, and even
damage to the product.
4.Click the “stop” buttom and unplug the power after juicing.
Warning：1)Please drink the juice immediately.
2)Must not apply to crush grain, sugar cane and hard fruit
(easily cause motor stuck and failure of mechanical).
Pusher
Inlet
Forward
Reverse
Press
Press
Stop
Forward
Reverse

10
Disassembling method
1.Power off the machine,unplug the power cord.
Attention:When finished juicing,please press the button of”Reverse” for easy to clean.
2.Catch hopper in one hand and the other catch the bowl and counterclockwise rotated,
then it can be isolated.
3.Catch the juice mouth of bowl and counterclockwise rotated then it can be Isolated.
4.Take out the squeezing screw, fine strainer and spinning brush.

11
5.Disperse the auger,rotation squeezing screw,fine strainer and spinning brush.

12
Cleaning Method
Cleaning
1.Wash the disassembled parts with flowingwater,if the meshes are blocked up by dreg,
please use the cleaning brush for the cleaning.
Attention：Please do not use iron wire brush,abradant or sharp cleaning tool for the
cleaning.
2. Do not make the mainframe put into water for cleaning and be sure to use wringed
soft cloth to clean it.
3. After cleaning,please dry the cleaned parts and store them in a clean and ventilating
place.
Attention：
1.Please wash the machine in time after use,otherwise the dreg will attach to the
container,which will affect the assembly and cleaning,and even result in performance
reduction.
2.The rubber pad at the bottom of the machine can be washed.
Maintenance
1. This product should be used often to keep the motor dry.
2.If the product not be used often,put the product stored in dry and ventilated place to
prevent the motor from damp moldy.

13
Troubleshooting
If the product has some abnormal situations such as: abnormal noise, odor, smoke,
etc., should be immediately cut off the power and stop use.
If product does not work,please check power supply is connected, the switch is
adjusted to the open position,and the hopper is installed correctly.
Phenomenon
Cause
Troubleshooting method
The running
machine stops
suddenly
Whether the power plug is
properly inserted
Make the plug inserted into the socket
The quantity of materials put
into the machine is too large
First,press”reverse”for 2-3s to make the
materials return upwards.Then press the
“forward”botton(repeat the process about 3
times).If the machine still not run,please clean
the machine before use.
Hard fruits and vegetables
are not cut.
Hard fruits and vegetables(such as carrot)shall
be squeezed after being cut into strips.
Safety switch loose
Make sure the switch assembled in place.
The juice
amount is small
or juice flows
out of the
mainframe
Dry materials stored in
refrigerator are used for
squeezing
Juice amount will increase if the materials are
squeezed after being immersed in clear water for
sufficient water absorption
The rubber pad at the bottom
of squeezing cup is not
installed properly
Please reinstall the squeezing rubber pad by
referring to the installation method
Abnormal
noise
Accessories are not properly
installed
Inspect whether the accessories are properly
installed after the machine stops
The machine is put on
oblique ground
Please put the machine on a plane
Parts cause extrusion sound
during squeezing
The sound caused by extrusion of fruits and
vegetables,and please do not worry about it
The container
and accessories
are dyed after
use
Dreg attaches to the
container
Clean the machine in time after use
The container and
accessories are liable to be
dyed when materials with
pigment(such as
carrot,spinach,etc.)are used
for squeezing
Clean the machine with detergent after it is
wiped with edible oil
Display E1
Automatic processing the
jammed food
No need to deal with
Display E2
Machine stuck
The user must clean the juice ingredients may
continue to use

14
If the product still does not work by above-mentioned check, please go to the
designated repair center to maintain and inquiry.
Circuit Principle

15
Service Description
1. The product warranty for one year (from the date of invoicing, the product intended
for home use only）.
2. During the warranty period, where failure caused by the quality of the product itself
please sent to the company for free repair with the completed "Warranty Card" and
machine invoices.
3. If the warranty period expired，and you want to buy some product accessories.
Contact with the customer service center of our company .
4. The special maintenance outlets have obligation to provide quality services to
customers，If you are unhappy with the service. You can complain directly to the
customer service center.
5. The following circumstances are not covered by the warranty：
⚫Did not follow the requirements of the specification to operate thereby causing
malfunction of the product.
⚫Damage due to consumer use, storage or maintenance incorrectly.
⚫Damage due to not dismantle repair by the company's own maintenance
department.
⚫Damage due to force majeure。
6. Though it is not part of the product under warranty, the company's customer service
center is still enthusiasm for your service.
7. If the product failure, please contact the company's authorized service center or
customer service center.

16
Warranty Card
Relevant information
User Name: Tel:
Add:
Model no. of Product: Item no. of Product:
Purchasing Shop: Purchasing Date:
Maintenance Point: Invoice No.:
Maintenance Record
Maintenance Date:
Fault Content:
Details of Maintenance:
Name of Maintenance Company:
Sign by Maintenance Company: Tel of Maintenance Company:
Maintenance Tel:
When buying our products, please fill out this warranty card immediately
Please keep the warranty card, and do not have to return it to the Company
Please bring the original warranty card and valid invoice for maintenance