Specification
Nozzle 0.3mm Inlet Thread 1/8” BSP
Fluid Cup Capacity 7cc
orking Pressure 15-50PSI
Operation
1 Put fluid into the cup after thinning appropriately.
2 Hold airbrush firmly in your hand.
3 By pressing the main lever, air will be released from the nozzle, drawing back on
the lever will release the paint.
4 The spray pattern is regulated by the distance between the work surface and the
airbrush.
5 For fine line spray, remove the needle cover and hold the airbrush close to work
surface.
Maintenance
1 Empty the fluid cup and wash with water or solvents with a brush.
2 Refill cup with water or solvent and block the needle cover with your finger and
pull back the trigger. The air will flow backward into the nozzle and remover any
paint remaining.
Parts Breakdown
1 FMT2130/1 Needle Cap
2 FMT2130/2 Nozzle Cap
3 FMT2130/3 Nozzle
4 FMT2130/4 O-Ring for Nozzle Cap
5 FMT2130/5 Needle
6 FMT2130/6 O-Ring
7 FMT2130/7 Needle Guide
8 FMT2130/8 Cup Lid
9 FMT2130/9 Trigger
10 FMT2130/10 Trigger Guide
11 FMT2130/11 Stopper
12 FMT2130/12 Spring
13 FMT2130/13 Spring Case
14 FMT2130/14 Needle Chucking Guide
15 FMT2130/15 Needle Chucking Net
16 FMT2130/16 Rear Body
17 FMT2130/17 Flow Rate Adjuster
18 FMT2130/18 Guide Screw
19 FMT2130/19 Lever Guide O-Ring 27 FMT2130/27 Hose Connector O-Ring
20 FMT2130/20 Valve O-Ring 28 FMT2130/28 Hose Connector
21 FMT2130/21 Valve Body 29 FMT2130/29 Nozzle Spanner
22 FMT2130/22 Valve Rod O-Ring 30 FMT2130/30 Airbrush Body
23 FMT2130/23 Valve Rod
24 FMT2130/24 Valve Spring
25 FMT2130/25 Valve Screw
26 FMT2130/26 Hose Connector Nut
F st Mover Tools Ltd
Unit 1 Frenchs Avenue, Dunst ble, LU6 1BH, United Kingdom
T: 0044 (0)1582 661993 E: s les@f stmovertoolsuk.com W: www.f stmovertoolsuk.com
Distribution Throughout Europe
FMT2130 Instruction Manual ise Precaution
This product is free from
contaminants. However,
we do recommend that you
flush your airbrush through
with a suitable thinner
before use as a
preventative precaution.
