FBS C12 User manual

C ution:
Wire devices in accordance
with the NEC.
If you are not sure about ex-
isting conductor wires, color
coding, polarity and circuit
feed contact a licensed
electrician.
Wrning:
o be installed and/or used
in accordance with appro-
priate electrical codes and
regulations.
Wrning:
o avoid fire, electrical
shock and/or electrocution
turn power OFF at the cir-
cuit breaker before wiring.
IMPOR AN : Please read carefully the following instructions before beginning.
1
OLD WORK
Unscrew the four screws at the
bottom of the box to remove
leveling feet.
2 3
Wire devices in accordance with the NEC.
Attach faceplates to mounting panels.
7
C12 - Ins t ll tion I nstructions -
4 5 Once con-
crete has
cured, remove
temporary
cover. Locate
and pull wires.
Hand toweling near box edges is suggested once
concrete has been poured.
Attach conduits to the selected
knockouts.
Install temporary cover to pre-
vent debris from entering the
box during concrete pour. Duct
tape any cracks or seams
where concrete may enter.
Fix and secure box to the floor
using concrete mix.
Add concrete mixture below
and around box (if necessary)
to level the box in accordance
to the final floor level desired.
Install the desired floor covering material (ter-
razzo, tile, limestone,carpet, etc) on the floor.
6
Determine box location and
position in accordance to floor
plans.
Adjust the leveling screws until
the desired level is met.
FBS FLOOR BOX SYS EMS
25060 Hancock Ave
S E 103-125
Murrieta, CA 92562
1-800-216-8307
Questions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.com

9 10
Installation Complete.Secure the cover to the box using the
four supplied screws.
Before installing the cover, apply a gener-
ous amount of silicone caulk around the
opening of the floor box (where the flange
sits) . Verify that all the perimeter has
been properly sealed.
8
Leveling the Box
CORRECT
ile or
Carpet
When a floor covering thickness is known in advance
(tile, wood, carpet), estimating level to obtain a floor cov-
ering flushed with floor box is suggested (as shown on
the figure above) However it is not completely necessary
When concrete is flushed with box, the
cover can be applied.
When concrete is over poured, the cover
can still be applied. Avoid this situ tion
***INCORRECT***
Concrete
Floor Box
ile
Floor Box Cover
Non-Beveled Cover Inst ll tion
C12 - Ins t ll tion I nstructions -
1) Depending on the thickness of
the floor covering material, level the
box as necessary to obtain a flush
finish between the cover and the
final floor level as shown on the illus-
tration.
2) Before installing the cover, apply
a generous amount of silicone caulk
around the opening of the floor box.
Verify that all the perimeter has been
properly sealed.
3) Secure the cover to the box using
the four supplied screws.
FBS FLOOR BOX SYS EMS
25060 Hancock Ave
S E 103-125
Murrieta, CA 92562
1-800-216-8307
Questions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.com